Sima Products SUR-20 user manual Battery low icon

Page 11

Chapter 2 —Getting Started

Battery low icon

When the batteries are low, the battery low icon will be displayed next to the power button:

Battery low icon

1

1

Figure 2-2: The battery low icon

You should replace the batteries with new ones immediately.

Battery tips and precautions

•Always use fresh batteries. Alkaline batteries recommended. Do not mix different types of batteries.

•Be sure that the positive (+) and negative (-) polarities of the batteries match the diagram shown in the compartment.

•Do not expose the batteries to excessive heat or flame.

•Keep batteries out of the reach of children.

•Weak batteries reduce the effective distance of the unit.

•Replace the batteries immediately when the battery low-

power warning icon appears in the information screen.

•To reduce danger of leakage and damage, remove used batteries when used longer than two years.

•The SUR-20 will not lose programmed data when batteries are replaced

5

Image 11

Contents With LCD touch screen Learning Universal RemotePage SUR-20 User’s Manual Table of Contents Iii Page Introducing the SUR-20 Unpacking the SUR-20 SUR-20 featuresFront and rear view Identifying componentsGetting Started BatteriesBattery low icon LCD Liquid Crystal Display Turning the LCD on Special function keys SUR-20 touch screen buttonsChanging the LCD layout Operating the SUR-20Changing the LCD Layout SUR-20 User’s Manual AUX device button Before you use the learning function Learning functionUsing the learning eye Using the learning functionFollow these instructions Press that device screen button Learn button to complete the learning mode Loading pre-programmed codes Press and hold for 5 seconds Loading Pre-programmed Codes Vendor Code Manufacturers’ Codes TelevisionsKEC Manufacturers’ Code VCRs Manufacturers’ Codes Cable BoxesJCL Manufacturers’ Code VCRs Manufacturers’ Codes DVDs Manufacturers’ Codes Satellite DishesDelete device button Using the delete functionDelete Function OK icon Delete Function Macro example Macro FunctionMacro Function You may need to set a time delay between turning on the VCR Macro Quick start guide to setting up a MacroFollow these instructions to set up a macro Adjusting the LCD backlight SUR-20 User’s Manual Special Features Turning off the beep signal Press each button until it disappears Recalling the original LCD layoutTV and DVD device buttons at the same time for five seconds Optional Accessories Appendix B TroubleshootingTroubleshooting Guide Function Enter Exit Chpt Quick Start GuideDay Limited Warranty Page To see our full line of products, visit us