Sima Products SUR-20 user manual Quick start guide to setting up a Macro

Page 39

Chapter 7 – Macro Function

and sending the tape play command.

Push the MACRO button to scroll through the 3 options: A = 2 sec. B = 5 sec. and C = 10 sec.

Select the 2-second delay (fig. A.).

Note: You can set a time delay between any two commands.

A. MACRO

2

B. MACRO

5

C. MACRO

10

Press play. This command will start playing the tape in your VCR when the macro is running.

Press LEARN to exit the macro sequence.

You can create another macro at this time by selecting another macro-run button and entering another sequence of commands.

…or press LEARN again to exit the macro function.

Running the macro

To run the macro, press the AUX device button. Press the 1 button. Be sure to aim the SUR-20 at the devices while the macro sequence is being sent. The following macro will begin:

1.	TV turns on	4.	Two-second delay.
2.	TV switches to video mode	5.	VCR starts playing tape
		5.	VCR starts playing tape

3.VCR turns on

To restore the AUX’s 1 button to its original function delete the macro using the delete button function. Refer to Using the delete function in Chpt. 6.

Quick start guide to setting up a Macro.

33

Image 39

Contents With LCD touch screen Learning Universal RemotePage SUR-20 User’s Manual Table of Contents Iii Page Introducing the SUR-20 Unpacking the SUR-20 SUR-20 featuresFront and rear view Identifying componentsGetting Started BatteriesBattery low icon LCD Liquid Crystal Display Turning the LCD on Special function keys SUR-20 touch screen buttonsChanging the LCD layout Operating the SUR-20Changing the LCD Layout SUR-20 User’s Manual AUX device button Before you use the learning function Learning functionUsing the learning eye Using the learning functionFollow these instructions Press that device screen button Learn button to complete the learning mode Loading pre-programmed codes Press and hold for 5 seconds Loading Pre-programmed Codes Vendor Code Manufacturers’ Codes TelevisionsKEC Manufacturers’ Code VCRs Manufacturers’ Codes Cable BoxesJCL Manufacturers’ Code VCRs Manufacturers’ Codes DVDs Manufacturers’ Codes Satellite DishesDelete device button Using the delete functionDelete Function OK icon Delete Function Macro example Macro FunctionMacro Function You may need to set a time delay between turning on the VCR Macro Quick start guide to setting up a MacroFollow these instructions to set up a macro Adjusting the LCD backlight SUR-20 User’s Manual Special Features Turning off the beep signal Recalling the original LCD layout TV and DVD device buttons at the same time for five secondsPress each button until it disappears Optional Accessories Appendix B TroubleshootingTroubleshooting Guide Function Enter Exit Chpt Quick Start GuideDay Limited Warranty Page To see our full line of products, visit us