Sima Products SUR-20 user manual Troubleshooting Guide

Page 48

The SUR-20 User’s Manual

Troubleshooting Guide (Cont.)

Macro does not	•	Be sure to aim SUR-20 at devices while macro
work		commands are being sent.
	•	Macro was not properly set up. Repeat macro
		set-up procedure ( Chpt. 7).
Record button	•	Record button has a three-second safety delay
does not work		to prevent accidental recording. Press and
		hold REC button for three seconds.
A button performs	•	Some remotes issue multiple commands when
its function two or		a button is held down. Re-teach the button
more times		being sure to release the button on your
		existing remote quickly when teaching the
		SUR-20.
The LCD screen	•	The SUR-20 is preset at the factory to
turns off.		automatically switch the LCD off after 20
		minutes if left unused. Just tap the LCD
		screen to turn the SUR-20 back on again.

See our web site www.simacorp.com for more information. Or call Sima at 800-345-7462

42

Image 48

Contents Learning Universal Remote With LCD touch screenPage SUR-20 User’s Manual Table of Contents Iii Page Introducing the SUR-20 SUR-20 features Unpacking the SUR-20Identifying components Front and rear viewBatteries Getting StartedBattery low icon LCD Liquid Crystal Display Turning the LCD on SUR-20 touch screen buttons Special function keysOperating the SUR-20 Changing the LCD layoutChanging the LCD Layout SUR-20 User’s Manual AUX device button Learning function Before you use the learning functionUsing the learning function Using the learning eyeFollow these instructions Press that device screen button Learn button to complete the learning mode Loading pre-programmed codes Press and hold for 5 seconds Loading Pre-programmed Codes Manufacturers’ Codes Televisions Vendor CodeKEC Manufacturers’ Codes Cable Boxes Manufacturers’ Code VCRsJCL Manufacturers’ Code VCRs Manufacturers’ Codes Satellite Dishes Manufacturers’ Codes DVDsUsing the delete function Delete device buttonDelete Function OK icon Delete Function Macro Function Macro exampleMacro Function You may need to set a time delay between turning on the VCR Quick start guide to setting up a Macro MacroFollow these instructions to set up a macro Adjusting the LCD backlight SUR-20 User’s Manual Special Features Turning off the beep signal Recalling the original LCD layout TV and DVD device buttons at the same time for five secondsPress each button until it disappears Optional Accessories Troubleshooting Appendix BTroubleshooting Guide Quick Start Guide Function Enter Exit ChptDay Limited Warranty Page To see our full line of products, visit us