Sima Products SUR-20 user manual Adjusting the LCD backlight

Page 41

Chapter 8

Overview: The following section will tell you how to:

•Adjust the sensitivity of the backlight.

•Turn off the beep signal.

•Recall the original LCD layout.

Adjusting the LCD backlight

You can adjust the LCD backlight sensitivity and the length of time that the backlight stays on after you press the LCD panel. Important Note: the room light sensor appears as a small dark spot located above the MACRO button at the top of the unit and it may be visible when the backlight is on. This is normal. Refer to these instructions:

Press the AMP and the AUX buttons at the same time for three seconds to enter the LCD backlight configuration mode.

You will hear two beeps and then see the password screen to the right.

Note: This screen prevents you from accidentally modifying your SUR-20.

35

Image 41

Contents With LCD touch screen Learning Universal RemotePage SUR-20 User’s Manual Table of Contents Iii Page Introducing the SUR-20 Unpacking the SUR-20 SUR-20 featuresFront and rear view Identifying componentsGetting Started BatteriesBattery low icon LCD Liquid Crystal Display Turning the LCD on Special function keys SUR-20 touch screen buttonsChanging the LCD layout Operating the SUR-20Changing the LCD Layout SUR-20 User’s Manual AUX device button Before you use the learning function Learning functionUsing the learning eye Using the learning functionFollow these instructions Press that device screen button Learn button to complete the learning mode Loading pre-programmed codes Press and hold for 5 seconds Loading Pre-programmed Codes Vendor Code Manufacturers’ Codes TelevisionsKEC Manufacturers’ Code VCRs Manufacturers’ Codes Cable BoxesJCL Manufacturers’ Code VCRs Manufacturers’ Codes DVDs Manufacturers’ Codes Satellite DishesDelete device button Using the delete functionDelete Function OK icon Delete Function Macro example Macro FunctionMacro Function You may need to set a time delay between turning on the VCR Macro Quick start guide to setting up a MacroFollow these instructions to set up a macro Adjusting the LCD backlight SUR-20 User’s Manual Special Features Turning off the beep signal Press each button until it disappears Recalling the original LCD layoutTV and DVD device buttons at the same time for five seconds Optional Accessories Appendix B TroubleshootingTroubleshooting Guide Function Enter Exit Chpt Quick Start GuideDay Limited Warranty Page To see our full line of products, visit us