ADVANCED FEATURES | CHAPTER 6 |
Use the Advanced Setup menu to configure alarm settings, motion detection, mobile surveillance, PTZ settings and network settings. The Advanced Setup menu contains the following
PICTURE
6.1 ALARM
Use the Alarm menu to configure alarm and email settings. External alarm devices must be connected to the alarm block on the rear panel of the system in order to use the I/O (input/ Output) alarms of the system.
The QS464 and QS4474 are not designed to use alarms.
The motion detection options for each alarm channel can be selected independently and are available below each port’s number.
|
| CHAPTER 6 |
|
| PICTURE | ADVANCED | |
ALARM SETTINGS |
| FEATURES | |
|
|
| |
I/O CHANNEL Consult your alarm’s manual for the proper settings. Select NO (Normal Open), NC (Normal Closed), or OFF.
HDD LOSS The alarm will sound if the internal hard drive is damaged
HDD SPACE The alarm will sound when the hard drive is full (if overwrite is disabled) | ||
VIDEO LOSS The alarm will sound when a camera is disconnected | ||
ALARM MANAGE Clicking on this button will open a new window. | ||
OUTPUT Set the output time (in seconds) |
| |
on the spot monitor from 0, 10, 20, 40, or 60 |
| |
seconds. |
| |
BUZZER Set the time (in seconds) for the |
| |
buzzer when an alarm is |
| |
40, or 60 seconds. |
| |
Set the buzzer to 0s if you want to disable the |
| |
alarm during motion detection |
| |
POST REC Set the time (in seconds) for the | PICTURE | |
system to record after a triggered | ||
| ||
10, 20, 40, or 60 seconds. |
| |
Click APPLY and then click CLOSE in the |
| |
confirmation window. |
| |
46 | 47 |