Q-See H264 user manual Time Tab, Record below, Stamp Tab, Snap Tab, Recycle Record Tab

Time Tab

You can set the length of time the DVRs record an event before and after a motion detection or alarm is triggered as well as how long an individual record is preserved.

Pre-alarm record time: This sets the length of time showing events prior to a motion detection or sensor-triggered event that is included in the record.

Post-alarm record: Sets the length of time - from 10 to 60 seconds - that is added to the record after the event is finished.

Expire time: The time - up to 60 days - that

an event is saved on the drive beforePICTURE 4-15it could be overwritten (See Recycle

Record below).

You can set up all channels with same values by selecting All and then configuring one channel.

Stamp Tab

Select which cameras will display their ID and date stamp and where it’ll appear on the screen.

Drag and drop the location of the camera name and date/time stamp to your desired location on the screen. This can be done individually or globally. A “Before” and “After” example is shown below.

PICTURE 4-16

PICTURE 4-17

Snap Tab

In this tab, you can configure how many still images are taken, the quality of the images and the timing between them when the Snapshot button is pushed on the Control Bar.

RECORD

Enable Record Bitrate Time	Stamp Recycle Record Snap
Resolution	CIF
Quality	Medium
Snap Time Interval [S]	2
Snap Number	1

Default Apply Exit

PICTURE 4-18

Recycle Record Tab

This is selected by default. Recycle record allows the DVR to record over old events when the hard drive is full. Otherwise, the DVR will stop recording when there is no more space available.

52 53