TV Installation – Rear Panel Connection Diagrams
CONNECTING TO AN
Connecting to Cable or Antenna through VCR
1.Make sure the power of the TV is turned off.
2.Make sure there is an antenna or cable connection to the VCR already.
3.Use a Coaxial RF cable and connect from your VCR’s Antenna Out or Output to TV to the ATSC/ NTSC port of your TV.
4.Turn on the TV.
5.Select TV (Air) for antenna or TV (Cable) for digital cable from either your remote control’s source button or source button on the TV.
6.Use the
Please Note :
1.Some VCRs must be turned On before its output will have a signal to the TV. Please consult your VCR manual for further reference.
2.Not all broadcasts are in High Definition (HD). Please refer to your local broadcasting stations for more information.
3.The MODEL 6560HD’s tuner is designed for HDTV therefore requires a stronger signal than normal TVs. If you cannot achieve that signal level with your antenna or cable, the TV might lose picture or sound.
4.This TV will turn off automatically if there’s no signal present for more than 15 minutes.
CONNECTING TO A DVD PLAYER | Connecting with |
| Component |
Connecting with HDMI (Best) | (Better) |
|
1.Make sure the power of the TV and your DVD player is turned off.
2.Connect a HDMI cable to the HDMI port of your DVD player and the other end to the HDMI port off the back of your TV.
3.Turn on the TV and your DVD player.
4.Use the remote control’s source button or the source button on the TV to switch to HDMI.
Please Note :
Refer to the DVD player’s manual to make sure the DVD player is configured to output correctly to the TV.
Please Note :
1.Refer to the DVD player’s manual to make sure the DVD player is configured to output correctly to the TV.
2.This TV does not decode Bit stream digital audio, so make sure the DVD is setup for PCM digital audio through HDMI.
3.If HDMI 1 is occupied, use HDMI 2 as your connection port.
1.Make sure the power of TV and your DVD player is turned off.
2.With a Component Cable, connect the green connector to the DVD player and Component 1’s green connector port on the TV.
3.Connect the blue color connector to your DVD player and Component 1’s blue connector port on the TV.
4.Connect the red color connector to both your DVD player and Component 1’s red connector port on the TV.
5.With an RCA Audio Cable, connect the white color connector to both your DVD player and Component 1’s white connector port on the TV.
6.Connect the red color connector to both your DVD player and
7.Component 1’s red connector port on the TV.
8.Turn on the TV and your DVD player. Use the remote control’s source button or the source button on the TV to switch to YPbPr1.
Please Note :
1.If Component 1 is already occupied, please use Component 2 as your connection port and switch to source YPbPr2.
2.Refer to the DVD player’s manual to make sure the DVD player is configured to output correctly to the TV.
3.This TV will turn off automatically if there’s no signal present for more than 15 minutes.
Page 12