TV Installation – Rear Panel Connection Diagrams
CONNECTING TO A SATELLITE OR CABLE | Connecting with |
| Component (Better) |
Connecting with HDMI (Best) |
|
1. | 1. Make sure the power of the TV and your | 1. | Make sure the power of TV and your |
| is turned off. | ||
2. | Connect a HDMI cable to the HDMI output of your | 2. | Obtain a Component Cable. Connect the green color |
| box and the other end to the HDMI port off the back of |
| connector to both your |
| your TV. |
| connector port off the back of your TV. |
3.Turn on the TV and your
4.Use the remote control’s source button or the source button on the right side of the TV to switch to HDMI 1.
Please Note :
1.Refer to the
2.If HDMI 1 is already occupied, use HDMI 1 as your connection port and switch source to HDMI 2.
3.SunBriteTV’s MODEL 6560HD supports SONY’s universal remote code. Please look up SONY’s codes in your universal remote’s hand book.
4.This TV will turn off automatically if there’s no signal present for more than 15 minutes.
3.Connect the blue color connector to both your
4.Connect the red color connector to both your
5.Obtain a RCA Audio Cable. Connect the white color connector to both your
6.Connect the red color connector to both your
7.Turn on the TV and your
8.Use the remote control’s source button or the source button on the TV to switch to YPbPr1.
Please Note :
1.If Component 1 is already occupied, please use Component 2 is your connection port and switch to source YPbPr2.
2.Please refer to the
3.SunBriteTV’s MODEL 6560HD supports SONY’s universal remote code. Please look up SONY’s codes in your universal remote’s hand book.
4.This TV will turn off automatically if there’s no signal present for more than 15 minutes.
Page 14 | Page 14 |