TV Installation – Rear Panel Internal Connect Source
Rear Panel Connections
WARNING: Do not connect the power source before making connections.
Internal Connect Source
The Internal Connect Source allows you to easily connect to the Audio, Video,
1.Unscrew the three Thumb Screws (Figure 1), and pull the cover towards you.
2.Route the cables to the proper inputs, and place the cable cords over the Rubber Sealing Gasket (Figure 2).
Note: There is an Indentation on the Rubber Sealing Gasket (on the bottom portion of the right and left sides). Make sure cable cords are not placed on the Indentation.
3.Close the cover.
4.Press firmly on the cover, and screw the Thumb Screws tightly (Figure 3).
Place the cables over the Rubber Sealing Gasket on the side of the cable door.
|
|
| Figure 2 | DO NOT place the |
|
|
| ||
|
|
| ||
Figure 1 | Thumb Screws |
| cables over these | |
|
|
|
| Indentations in |
|
|
|
| the corners of the |
|
|
|
| cable door. |
Figure 3
Page 8