TV Installation – Rear Panel Connection Diagrams
CONNECTING TO AN EXTERNAL AMPLIFIER OR AMPLIFIED SPEAKERS
Connecting with Coaxial SPDIF Digital (Best)
Connecting with RCA Audio Analog (Good)
1.1. Make sure the power of the TV and your receiver is turned off.
2.Obtain a Coaxial SPDIF cable, connect it to your receiver’s coaxial SPDIF digital input and the Coaxial SPDIF connection on the LINE OUT port off the back of the TV.
3.Turn on the TV and your receiver.
Please Note :
1.If you want pure digital stream for your receiver to decode, you must also configure the TV’s OSD Sound- >Digital Audio Out function. Make sure the option is on Bit Stream.
2.If your receiver is making static noises when receiving Bit Stream, you must use the PCM option instead.
3.Refer to the receiver’s manual to make sure the receiver is configured to receive signals correctly from the TV
1.1. Make sure the power of the TV and your receiver is turned off.
2.Obtain a 3.5mm stereo/audio cable (if your amplifier audio connection requires RCA audio out jacks you will need to obtain an 1/8” Stereo Mini Plug to RCA adapter cable). Connect it to your receiver’s audio input connection and the 3.5mm stereo/audio connection on the Analog Audio port on the back of the TV.
3.Turn on the TV and your receiver.
Please Note :
1.If you want pure digital stream for your receiver to decode, you must also configure the TV’s OSD Sound- >Digital Audio Out function. Make sure the option is on Bit Stream.
2.If your receiver is making static noises when receiving Bit
3.Stream, you must use the PCM option instead.
4.Refer to the receiver’s manual to make sure the receiver is configured to receive signals correctly from the TV
Connecting with DVI Digital (Best)
Page 16
1.Make sure the power of the TV and your receiver is turned off.
2.Obtain a HDMI to DVI conversion cable; connect the DVI side of the conversion cable to the DVI output of your PC, and the HDMI side of the conversion cable to the HDMI port off the back of TV.
3.Obtain a 3.5 mm
4.Turn on the power to the TV and the PC.
5.From the remote control’s source button, or the Source button from the TVs panel, switch to HDMI.
Please Note :
1.For the best picture, set your PC resolution to 920 x 1080 at 60 Hz. Refer to the PC or graphic card manual for further instructions on how to set your resolution and refresh rate.
2.Refer to your PC manual for video output requirements of the video card.
3.The TV will turn off automatically if there’s no signal present for more than 15 minutes.
4.If HDMI 1 is already occupied, use HDMI 2 as your connection port, and switch source to HDMI 2.
Continued on next page