Configuration Setting Switches (SW)
NO. | FUNCTION | SETTINGS | |
SW1 | TP Port mode | OFF | |
|
| ON | Forced mode |
SW2 | TP Port Duplex | OFF | Full duplex (default) |
|
| ON | Half duplex |
SW3 | TP Port Speed | OFF | 100Mbps (default) |
|
| ON | 10Mbps |
SW4 | 802.3x function | OFF | Enable (default) |
|
| ON | Disable |
SW5 | FX1 port duplex | OFF | Full duplex mode (default) |
|
| ON | Half duplex mode |
SW6 | FX2 port duplex | OFF | Full duplex mode (default) |
|
| ON | Half duplex mode |
LEDIndicators
LED | DISPLAY | STATE INTERPRETATION | |
PWR | Power status | ON | Power on |
|
| OFF | Power off |
TP LINK | TP port link status | ON | Link up and no traffic |
|
| OFF | Link fault |
|
| BLINK | Rx/Tx activities |
TP 100M | TP port speed status | ON | 100Mbps |
|
| OFF | 10Mbps |
TP FDX | TP port duplex status | ON | Full duplex |
|
| OFF | Half duplex |
|
| BLINK | Collisions on half duplex |
FX1 LINK FX1 port link status | ON | Link up and no traffic | |
|
| OFF | Link fault |
|
| BLINK | Rx/Tx activities |
FX1 OL | FX1 port optical link | ON | Optical signal is detected |
|
| OFF | No optical signal |
FX2 LINK FX2 port link status | ON | Link up and no traffic | |
|
| OFF | Link fault |
|
| BLINK | Rx/Tx activities |
FX2 OL | FX2 port optical link | ON | Optical signal is detected |
|
| OFF | No optical signal |