KTI Networks KCD-302 manual FX Port Duplex Settings SW5 SW6, Factory Default Settings

3.1.3 FX Port Duplex Settings SW5 SW6

This settings are used to set the duplex mode of the FX1 port and FX2 port individually. It is recommended to use full duplex mode for FX con- nection unless its link partner is a fixed half duplex device. Half duplex mode will shorten the connection distance. The following table lists the maximum MMF cable length connecting to different devices:

Link Partner of FX Port	Distance (MMF cable)
Network card half-duplex fiber port	400m
Network card full-duplex fiber port	2km
Class I hub half-duplex fiber port	160m
2 Class II hub half-duplex fiber port	112m
Switched half-duplex fiber port	400m
Switched half-duplex fiber port	2km

Note: For SMF connection, be sure the link partner is a full duplex device and set SW5 SW6 to full duplex mode for the FX ports.

3.1.4 Factory Default Settings

The factory default settings are as follows:

SW1	OFF	TP port mode - auto-negotiation
SW2	OFF	TP port - full duplex
SW3	OFF	TP port - 100Mbps
SW4	OFF	Enable IEEE 802.3x flow control function
SW5	OFF	FX1 port - full duplex
SW6	OFF	FX2 port - full duplex

-28-