KTI Networks KCD-302 manual Configuration Switches, TP Port Settings SW1-SW3

Page 27

3.1 Configuration Switches

SW

FUNCTION

SETTING & STATE

SW1

TP Port mode

OFF

Auto-negotiation (default)

 

 

ON

Forced mode

SW2

TP Port Duplex

OFF

Full duplex (default)

 

 

ON

Half duplex

SW3

TP Port Speed

OFF

100Mbps (default)

 

 

ON

10Mbps

SW4

802.3x function

OFF

Enable (default)

 

 

ON

Disable

SW5

FX1 port duplex

OFF

Full duplex mode (default)

 

 

ON

Half duplex mode

SW6

FX2 port duplex

OFF

Full duplex mode (default)

 

 

ON

Half duplex mode

3.1.1 TP Port Settings SW1-SW3

SW1, SW2, SW3 are used for configuring the TP port especially when connecting to a link partner port which is not auto-negotiation capable. Refer to section 2.5 for details.

3.1.2 802.3x Function Setting SW4

IEEE 802.3x function is the flow control method used for full duplex op- eration on the TP port and FX ports under store and forward mode. This method uses pause frames for one port to stop further transmission from its link partner.

-27-

Image 27
Contents Tri-segment Media Converter IndustrialInternational United StatesEthernet is a registered trademark of Xerox Corp Table of Contents Introduction Page Features Specifications Fiber Optic Interfaces FX1 Port, FX2 Port Twisted-Pair Interface TP Port, or called copper PortLEDIndicators Configuration Setting Switches SWEnvironmental DC Power InputBasic Information MechanicalCE/EMC CertificateModel Specifications Model SpecificationsOptical Specifications Auto-negotiation Function Far End Fault FunctionSpecial Functions Auto MDI/MDI-X FunctionUnpacking InstallationDIN-Rail Mounting Page Page Mounting on a Plane Surface Page Applying Power DC Power Input SpecificationDC Power Terminal Block DC Power Jack Configuration Setup Making TP Port ConnectionNetwork Cables Making FX Port Connections Multimode MMF 50/125, 62.5/125 mm SinglemodeSMF-9/125mm Configuration Switches & LED Indicators Configuration Switches TP Port Settings SW1-SW32 802.3x Function Setting SW4 FX Port Duplex Settings SW5 SW6 Factory Default SettingsLink Partner of FX Port Distance MMF cable LED Display Status & Interpretation LED Indicators