Humax Digital Set-Top Box manual GB49, Moving to a pre-set satellite

6. Moving to a pre-set satellite

Once you have stored the positions of the satellites you want (see below left) you can search for the services transmitted from them. Before doing this, you must move the motor to the position of the satellite you wish to search for. To do this, you must access the Satellite Settings menu. Proceed as follows:

1.Select “Service Searching” from the Main menu and press theOK ( ) button to display the Service Searching menu.

2.Select the Manual Search option and press the OK ( ) button to display the Manual Search menu.

3.Select the Alternative Antenna option and press the OK ( ) button to display the Satellite Settings menu.

4.In the Satellite Settings menu ensure that you have the DiSEqC Command Mode option set to “User”.

5.	Highlight the option Satellite Name and use the		buttons to select the satellite you want
	to view.
6.	When you have selected the satellite you wish to view, go down to the Motor Control option and,
	using the	buttons again, select “Go to” and press theOK (		) button.

7.The motor will now move to the selected satellite’s position.

8.The Movement option is used to fine-tune the motor’s position.

9.When using the Movement option for fine-tuning, you must remember to store the changes you have made, otherwise they will be lost.

7.Searching for services on your selected Satellite

Once you have moved the motor into position, you can search for the channels transmitted from the relevant satellite. To search for services on your new selected satellite, proceed as follows:

1.Move the motor to the position of the satellite you wish to search for (see section 6 above):

2.Select “Service Searching” from the Main menu and press the OK ( ) button to display the Service Searching menu.

3.Select the manual search option and press the OK ( ) button to display the Manual Search menu.

4.Now enter the Frequency and Symbol Rate using the NUMERIC

buttons (0~9).

Next, enter the Polarisation and FEC values using the buttons.

5.When you have entered all these details, press the OK ( ) button and the search will begin.

6.When the search has finished, press the OK ( ) button to view.

7.Repeat the process for all the transponders you want from this satellite.

GB49