9. Installation
9.1 Welcome to Fortec Star HD World
yThe very first time you turn your receiver on, or after a Factory Reset, the language selection menu appears on your TV screen.
yUse the e/f/▲/▼ buttons to select the language.
yPress OK button to go to next step.
9.2 How to Set Up your Antenna
9.2.1 Antenna Settings
ySelect the satellite by pressing e/f buttons and choose from the list.
ySelect your LNB type using thee/f buttons.
ySelect the correct DiSEqC setting for your antenna. If you have a single antenna, chose OFF. Otherwise, chose the corresponding DiSEqC output.
ySelect DiSEqC 1.1 setting if you are using 4 or more LNB’s.
yChoose an active TP for the selected satellite (You will only get a signal from an active TP. If in doubt, please check www.lyngsat.com or www.satcodx.com for a TP
that is broadcasting a channel. These Web sites provide a full list of all satellites and the channels available on each satellite.)
yUse Power ON if the receiver is going to feed the LNB. (This is typically the case.)
ySelect DiSEqC 1.2 or USALS if you are going to use a motor. If so, after selecting it press OK in order to set up the motor parameters.
yIf the setting is completed, your antenna is set up properly and pointed correctly to the selected satellite the two bars will show the level and quality of the signal.
ySave the current setting using the Red button on the remote control.
22