Installation Instructions |
Projector Installation to Mount
WARNING: IMPROPER INSTALLATION CAN LEAD TO PROJECTOR FALLING RESULTING IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT. DO NOT substitute hardware. Use only the hardware provided by the manufacturer.
1.Secure interface bracket (AA) to top of InFocus projector (not included) using hardware and instructions included with the interface bracket.
2.Orient projector with attached interface bracket as shown. (See Figure 16)
3.Lift projector so that screws with thumb nuts are aligned with mounting slots in mount base. (See Figure 16)
4.Slide projector with interface bracket onto mounting slots in projector mount (F) until screws are seated against the back of mounting slots. (See Figure 16)
Thumb nuts | 4 |
3 
(E)
(Interface appearance is example only. Appearance may vary.)
7 Lock | 6 |
| Locking |
| lever |
| 6 |
5 |
|
Mounting screw |
|
with thumb nut |
|
seated in |
|
mounting slot |
|
(reverse view) |
|
Figure 17
Projector Mount Adjustments
Yaw Adjustment
1.Loosen yaw adjustment locking screw using a #2 Phillips screwdriver. (See Figure )
2.Turn Yaw
3.Tighten Yaw adjustment locking screw using a #2 Phillips screwdriver. (See Figure )
Figure 16 | 1 | 3 |
WARNING: IMPROPER INSTALLATION CAN LEAD TO PROJECTOR FALLING RESULTING IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make certain mounting slots in projector mount slide under thumb screws and that screws are seated in the back of slots.
5.Verify mounting screws are properly seated in mounting slots in projector mount. (See Figure 17)
6.Move locking lever to "locked" position. (See Figure 17)
7.Insert key into lock and turn to secure projector to mount.
(See Figure 17)
2
2
Figure 18
10 | Visit the InFocus support site at www.infocus.com/support |