Installation Instructions |
Installing Mount Covers
1.Raise lower cover (D) up to wall mount assembly. (See Figure 12)
1 |
(D) |
Figure 12
2.Lower top cover (C) onto wall mount assembly. (See Figure 13)
3.Install two #10 x 1" Phillips pan head tapping screws (V) through holes on sides of covers. (See Figure 13)
4.Install two #8 x 1/2" Phillips pan head tapping screws (U) into top of top cover (C). (See Figure 13)
| 3 | (V) x 2 |
4 | (U) x 2 |
|
| 2 |
|
|
| (C) |
Figure 13
Projector Installation
WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components attached to the short throw projector mounts up to (and including) the projector does not exceed 25 lbs (11.34 kg) for the
Holes for projector mount |
(bottom view) |
Figure 14
Projector Mount Installation
1.Line up mounting holes on projector mount (E) with corresponding holes on mounting plate. (See Figure 14)
2.Install four
IMPORTANT ! : If projector mount is NOT installed in the same direction as shown, ROLL adjustment screws will be inaccessible! (See Figure 15)
| Mounting plate |
(E) | Roll adjustment screws |
| |
2 | (W) x 4 |
Figure 15
Visit the InFocus support site at www.infocus.com/support | 9 |