InFocus infocus single stud short throw wall mount manual Pitch Adjustment Entire Arm

PRJ-WALLKIT-11 Installation Instructions

Pitch Adjustment - Entire Arm

1.Loosen two 5/16-18 x 1/2" hex head screws (T) (one on each side of wall bracket). (See Figure 22)

2.Loosen two bolts (one on each side of pitch adjustment screw). (See Figure 22)

3.Adjust pitch adjustment screw until mount is at desired pitch level.

•Turn clockwise to raise mounting level.

•Turn counterclockwise to lower mounting level. (See Figure 22)

4.Tighten two bolts (one bolt on either side of pitch adjustment screw). (See Figure 22)

5.Tighten two 5/16-18 x 1/2" hex head screws (T) (one on each side of mounting bracket). (See Figure 22)

		2	4
Raise	Lower
	or
	3
	1	5
			(T) x 2

Figure 22

6.Return mount covers to the mount following instructions in Installing Mount Covers section.

Cable Management (Optional)

NOTE: In most cases, the cable management cover will NOT need to be removed in order to route cables from projector to the wall mount. But for some thick cables, removing the cover may be necessary.

NOTE: Remove mount covers from the mount following instructions in Removing Mount Covers section.

1.Remove cable management covers (if necessary) from short throw projector arm. (See Figure 23)

	(projector not shown)
1
[Small cable cover]	1
[Large cable cover]

Figure 23

2.Route projector cable(s) under mount cover and through short throw projector arm tunnel. (See Figure 24)

(projector not shown)

2 Cable(s)

Figure 24

12 Visit the InFocus support site at www.infocus.com/support