Stop bracket | InFocus infocus single stud short throw wall mount

PRJ-WALLKIT-11

Installation Instructions

3.Remove two bolts holding stop bracket in place on

underside of short throw projector mount. (See Figure 29)

	Stop bracket
3	x 2

Figure 29

4.Install two 1/4-20 x 1/2" button head security screws (K) through holes in stop bracket and into holes in sliding nuts. (See Figure 30)

	Sliding nuts
Stop bracket
4	(K) x 2

Figure 30

5.(Optional) Remove projector from short throw projector mount according to projector interface instructions.

NOTE: For most projectors, it will be necessary to remove projector prior to install four security screws to projector bracket. For ease of installation, it is recommended to remove projector prior to performing the following steps.

6.Remove one of four bolts from adapter plate. (See Figure 31)

Adapter plate

6x 4 (one at a time)

Figure 31

7.Install one 1/4-20 x 3/4" button head security screw (L) into hole vacated by removing bolt in Step 6 and into plastic spacer. (See Figure 32)

8.Repeat Steps 6-7 for remaining three bolts one bolt at a time.

9.It is important to replace adapter plate bolts ONE AT A TIME or adapter plate could fall from mount during installation!

Adapter plate
Plastic spacer
7	(L) x 4 (one at a time)

Figure 32

10.Reinstall projector to mount. Refer to Projector Installation section for details.

14	Visit the InFocus support site at www.infocus.com/support