InFocus infocus single stud short throw wall mount instruction

PRJ-WALLKIT-11

Installation Instructions

ASSEMBLY AND INSTALLATION

The single stud short throw wall mount can be mounted to concrete, concrete block, 2" x 4" wood studs or steel studs.

Installing Mounting Bracket

WARNING: ELECTRICAL SHOCK HAZARD! CUTTING OR DRILLING INTO ELECTRICAL CORDS OR CABLES CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! ALWAYS make certain area behind mounting surface is free of electrical wires and cables before cutting, drilling, or installing fasteners.

WARNING: EXPLOSION AND FIRE HAZARD! CUTTING OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! ALWAYS make certain area behind mounting surface is free of gas, water, waste, or any other plumbing before cutting, drilling, or installing fasteners.

Mounting Wall Bracket

Concrete or Concrete Block

1.Determine mounting location on wall.

2.Using wall bracket (B) as a template, mark four holes at the outer holes in bracket. (See Figure 1)

3.Drill four 3/8" x 3-3/8" deep holes at marked locations in wall. (See Figure 1)

(front view)

(B)

	4	(Y) x 4
	(Q) x 4
5	(P) x 4
	(B)

Figure 2

Wood Studs

1.Determine mounting location on wall. Use a stud finder to locate studs.

2.Line up inner three holes on wall bracket (B) with center of stud at desired mounting location. (See Figure 3)

3.Using wall bracket (B) as a template, mark three holes at inner three holes in bracket. (See Figure 3)

4.Drill three 7/32" x 2-1/2" deep holes at locations marked in Step 3. (See Figure 3)

x 4

Figure 1

4.Install four concrete anchors (Y) into drilled holes. (See Figure 2)

5.Install four 5/16 x 2-1/2" hex head lag screws (P) through four 5/16" washers (Q), outer holes of wall bracket (B) and into concrete anchors (Y). (See Figure 2)

(front view)

(B)

wood stud

x 3

Figure 3

6	Visit the InFocus support site at www.infocus.com/support