InFocus infocus single stud short throw wall mount manual Installation to Wall Bracket

PRJ-WALLKIT-11 Installation Instructions

10.Place wall bracket (B) over anchors and align mounting holes in display mount with holes in anchors. (See Figure 9)

11.Insert 1/4-20 x 1-3/4" Phillips pan head screws (F) through 1/4" washer (G), corresponding mounting hole on wall bracket and into anchor (H) and tighten until flush against mount. DO NOT overtighten! (See Figure 9)

12.Repeat Steps 10 through 11 for remaining 2 mounting holes.

WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Overtightening of mounting hardware can damage the steel studs. DO NOT overtighten mounting hardware!

(side view)
	Steel Stud
	Drywall
	(G) x 3
11	(F) x 3
	(B)
	Anchor Metal Channel

Figure 9

Installation to Wall Bracket

1.Lift wall mount assembly (A) up to wall bracket (B) and hook upper plate over upper notches on bracket. (See Figure 10)

2.Slide lower plate into lower notches on bracket. (See Figure 10)

Upper plate	1	(B)
		1
		2
(A)	Lower plate

Figure 10

3.Fasten wall mount assembly (A) to wall bracket (B) using two 5/16-18 x 1/2" hex head cap screws (T) through two 5/16" washers (Z), the wall bracket and wall mount assembly. (See Figure 11)

3	(T) x 2
(A)
(B)	(Z) x 2

Figure 11

8 Visit the InFocus support site at www.infocus.com/support