PNR Series | Installation Instructions |
Removing Display from Mount
1.Remove bolt or padlock from faceplate (if used).
NOTE: The pin may have been used as a more permanent locking device. If so, remove nut and pin and move from the lower holes to the upper holes.
2.Pull back on flag on upper mounting hole and press pin down into "Open" position. (See Figure 18)
WARNING: DISPLAY MAY WEIGH IN EXCESS OF 40 LBS! Always use two people and proper lifting techniques when installing or positioning display on mount.
1 | Remove bolt |
|
| or padlock | 2 |
| if used. | |
Pin in |
| |
"Closed" |
| |
position - |
| |
move to |
| |
"Open" |
| |
position to |
| |
remove |
| |
display. |
| |
Figure 18
3.Carefully lift display from mount
4.Lift up on pin and place flag back against faceplate to return it to "Closed" position. (See Figure 19)
4 |
Pin in |
"Open" |
position - |
move to |
"Closed" |
position |
after display |
is removed. |
Figure 19
14