Chief Manufacturing PNR Series Swivel Tension Adjustment, Swing Arm Adjustments

Installation Instructions PNR Series

Swivel Tension Adjustment

CAUTION: DO NOT OVER TIGHTEN SWIVEL ADJUSTMENT NUT. Over tightening swivel adjustment nut will cause excessive wear and may distort adjustment components.

1.Using a 9/16” wrench (not provided), slightly tighten or loosen swivel tension adjustment nut. (See Figure 11)

2.Repeat until desired tilt tension is obtained.

Roll Tension Adjustment

1.If necessary, loosen or tighten roll tension adjustment nut. (See Figure 11)

2.Repeat until desired rotational tilt tension is obtained.

Swivel tension

adjustment nut

Roll tension

adjustment nut

Figure 11

Swing Arm Adjustments

The dual swing arms are shipped installed in the center of the top and bottom mounting brackets, which is the standard mounting configuration.

The top and bottom mounting brackets have slotted holes, allowing for lateral adjustment of the dual swing arms.

After installing top and bottom mounting brackets between two wood studs 16” on center, the swing arms can be adjusted or moved off center, depending on the location of the mount, size of display, and lateral movement needed to rotate the display.

The swing arms can be adjusted, as follows:

•Adjusting the Swing Arms Off-Center

With no disassembly required, you can adjust the swing arms up to 1-inch to the left of center or up to 1-inch to the right of center.

•Reconfiguring the Swing Arms Left of Center

With some disassembly and reassembly required, you can move the swing arms to the left of center by reconfiguring the mount. Use the first and third slotted holes in the top and bottom mounting brackets.

•Reconfiguring the Swing Arms Right of Center With some disassembly and reassembly, you can move the swing arms to the right of center by reconfiguring the mount. Use the third and fifth slotted holes in the top and bottom mounting brackets.

Adjusting the Swing Arms Off Center

1.Remove the display from the mount.

2.Loosen four bolts (two on the top and two on the bottom) securing the swing arm assembly to top and bottom mounting brackets (See Figure 12).

3.Move the swing arm assembly left or right within slots to desired location.

4.Tighten the bolts.

5.Install the display on the mount.

Top bolts

Figure 12

11