Installation Instructions | PNR Series |
Installing Mount to Wall
WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to make sure the structure to which the mount is being installed is capable of supporting five times the combined weight of the mount and all attachments.
NOTE: The following instructions assume a suitable mounting structure and surface exists prior to installation.
CAUTION: To avoid personal injury, use an assistant when lifting, lowering or holding PNR during installation.
1.Determine mounting location taking into consideration display size and PNR’s range of movement.
2.Using a stud sensor locate two wood studs 16” on center. (See Figure 1)
| 16" |
| Wood Studs |
(Wall) | Pilot |
Holes |
Figure 1
3.Place and level mount against wall, aligning mounting holes in upper and lower wall channels with studs. (See Figure 2)
4.Mark four mounting holes making sure mounting holes are located as close as possible to center of studs.
(See Figure 2)
5.Drill four 7/32" pilot holes where the mounting holes were marked. (See Figure 2)
1
3
3
4 |
|
5 | x 4 |
Figure 2
7