Model | Installation Instructions |
|
|
CABLE MANAGEMENT
WARNING: Make sure your cables do not run through a pinch point.
1.Connect and secure power/audio/video cables, making sure to leave sufficient slack to allow for movement of the display.
2.Route power/audio/video cables under each arm, allowing sufficient slack in cables for extension and avoiding pinch points.
3.Secure cables using two cover plates (160) and four screws (90). (see figure 11)
ADJUSTMENTS
LATERAL TENSION ADJUSTMENT
CAUTION: Overtightening adjustment will cause excessive wear.
1.Using a 3/16” hex wrench (170), slightly tighten or loosen lateral tension adjustment bolts.
(see figure 12)
2.Check for desired tension.
3.Repeat Steps 1 and 2 until desired tension is obtained.
PITCH ADJUSTMENT
CAUTION: Overtightening adjustment screw will cause excessive wear.
NOTE: Remove display to make pitch adjustment.
1.Check adjustment screw on the Centris interface to ensure that the screw is tight. (see figure 13)
2.If needed, use a 3/16” hex wrench (170) to tighten the screw.
160
90
Figure 11: Cable Management
Lateral Tension
Adjustment Bolts
Figure 12: Adjust Lateral Tension
Pitch Tension
Adjustment Screw
Figure 13: Pitch Adjustment
10