Kathrein UFD 400 manual Adjusting volume, balance and tone, Muting the sound

Receiver operation

Note	With the setting “2- or 3-digit programme selection“ there is a switch to the desired
	programme after approximately 3 seconds. Digits can be entered during this time.
	With the setting “free entry“ (in the above example) the receiver switches to the
	corresponding programme slot immediately after each input.
	In the initial setup menu, a continuous on-screen display of the programme slot can
	be selected (see section: “Initial settings, On Screen Displays“).

Adjusting volume, balance and tone

∙Use the keys to adjust the volume to the desired level.

The volume is adjustable in 21 steps. The volume level set appears on the LED display for approximately 3 seconds. At the same time a bar indicator appears on the screen.

Note	The settings are not operative on the VCR Scart socket in order not to disturb any
	recordings.
	The on-screen display is removed again after approximately 3 seconds.
	Whilst the menu for volume adjustment is overlaid, the	key can be used to acti-
	vate the following menu for balance adjustment, tone adjustment, stereo width and
	pseudo-stereo.

	Using the	keys or the	key you can select the particular menu entry and
	then make changes with the		keys.
Note	In the menu entry “Stereo Width" the stereo base width can be adjusted independ-
	ently.
	“Pseudo-Stereo" can be used to simulate a “stereo-like“ effect with mono pro-

grammes, and should thus only be activated with mono reception.

If Pseudo-Stereo has been turned “On“, the stereo width can no longer be altered.

Muting the sound

∙Press the key.

	The sound is muted, allowing you to make a phone call undisturbed, for example.
	In the LED display the sound muting is shown by means of 3 dots.
Note	∙ Press the	key again to turn the sound back on.
	Mute is not operative at the VCR Scart socket.

11