Initial settings

Exit from the menu with the key.

DiSEqC menu

Fundamentals of the DiSEqC signal (Digital Satellite Equipment Control)

In order to select the satellite signals different control signals are required.

Up until now, the 14/18V LNB supply voltage and the 22 kHz signal (superimposed on the LNB supply voltage) have been sufficient for signal selection for the majority of applications.

With these four control criteria it is possible to switch between horizontally and ver- tically polarised signals, as well as between two satellites (multifeed reception).

With the extension of the frequency range to the 12 GHz region (high-band region

11.70– 12.75 GHz) or for reception of more than two satellites, additional control criteria are required for LNB selection and signal selection.

The “DiSEqC“ control signal is, in fact, a special form of modulation (pulse-width modulation) of the already existing 22 kHz signal.

The UFD 400 receiver is equipped with:

DiSEqC tone burst

(also termed Simple DiSEqC or just DiSEqC) and

DiSEqC 1.1

The setting required is dependent on the components of your receiving system.

Setting options in the DiSEqC menu

Call the initial setup menu (see paragraph “Calling the initial setup menu“).

Using the keys move to menu entry “DiSEqC menu . . .“.

Activate the submenu “DiSEqC menu . . .“.using the keys

The following menu appears (factory preset):

Setting option:

 

22 kHz Signal:

Off, High/Low, Pos A/B

Tone Burst:

Off, Pos A/B, Opt A/B, High/Low

DiSEqC:

Off, On

DiSEqC Repeat: Off, 1 or 2

UFO mini:

Off, On, UFO twin 1, UFO twin 2

Remote Freq.:

0-2150 MHz

UFO micro:

Off, On, Reset

The bottom line shows the keys you can use to make the settings.

22 kHz signal

In this menu entry, you specify whether the 22 kHz signal is to be used to switch between a satellite‘s lower and upper frequency range (low/high) or to switch be- tween two satellite positions (Pos. A/B).

22 kHz

 

 

or

22 kHz

 

 

High/Low

Freq. range

22 kHz

 

Pos. A/B

Orbit Pos.

22 kHz

 

 

 

 

 

 

 

 

Low

Off

 

 

1 and 3

Off

 

High

On

 

 

2 and 4

On

 

 

 

 

 

 

 

26

Page 26
Image 26
Kathrein UFD 400 manual KHz signal, Setting options in the DiSEqC menu