
Initial settings
Note | The setting is therefore to be made according to information in the “Subscriber- |
| controlled preprocessing system“ installation guide. |
Remote frequency
| If you have set "On" or “UFO twin 1“ in menu entry UFO mini, make the setting in |
| this menu entry for the transmission frequency. |
| The particular transmission frequency that needs to be set in the range 0 to 2150 |
| MHz is given in the |
| guide”. |
Note | It is therefore essential to note the installation guide instructions of the “Subscriber- |
| controlled preprocessing system“. |
UFO micro
The setting in this menu entry is also designed for operation of the receiver on a
Here control and communication between the receiver and the Kathrein “UFO mi- cro" system is effected via the return path of the coaxial cable.
If the UFD 400 receiver is operated on a “UFO micro“ receiving system, an “ On" setting must be made in menu entry “UFO micro".
A special address is then assigned to the receiver by the receiving system during installation, so that control commands sent by the receiver to the receiving system for signal selection will also be recognised by it.
A remote frequency does not need to be set up in this mode of operation since this is determined by the “UFO micro" system with the addressing.
If the receiver is used on different receiving systems the previously assigned ad- dress is to be deleted. This is done in menu entry “Reset".
As a result, the receiver is then assigned the
Note | The | ||||
| Default: Off |
|
|
| |
| ∙ | Press the | key twice to save your settings. | ||
| ∙ |
| |||
Note | Exit the initial setup menu with the |
| key (press twice). | ||
| |||||
If you exit the menus without saving, the settings will be lost. |
Switching over remote control’s command set
The remote control handset contains two command sets. This allows two receivers to be operated independently in a room (not in conjunction with a twin receiver).
Note | Switchover is possible for remote controls that have 24 and 26 keys. |
| |||||||||
| For this purpose, programme one receiver on command set 1 and the second re- | ||||||||||
| ceiver on command set 2. |
| |||||||||
| ∙ | Switch on receiver 1. Switch off receiver 2 using the mains switch | on the | ||||||||
|
| unit. |
|
|
|
|
|
|
|
|
|
|
| ⇒ Press the |
| key and keep it pressed. |
| ||||||
|
|
|
| ||||||||
|
|
|
| ||||||||
|
|
|
|
|
|
|
| ||||
| ∙ | ⇒ Using the numeric keys |
| ... |
| enter “901“. |
| ||||
|
|
|
| ||||||||
|
| ||||||||||
| To adopt the code, switch receiver 1 into standby using the |
| key, and then | ||||||||
|
|
28