The modem does not | Check that the COM port to which the |
respond when, in | modem is connected is properly |
terminal mode, you | declared. Check the IRQ configuration in |
send AT commands. | the communications software or in the |
| Windows Control Panel. Check that |
| the application is in terminal mode. |
| If none of the preceeding solutions solve |
| the problem, it means that the modem is |
| certainly in conflict at the COM port/IRQ |
| level. Begin the installation procedure in |
| the Installation chapter. If you change |
| the COM/IRQ configuration, don't forget |
| to make these changes in the application |
| as well. |
|
|
The modem cannot | Check the connection to the telephone |
make a call and sends | line. It could be that the modem cannot |
the message ‘NO DIAL | detect the dial tone. |
TONE’. | Try the ATX3DT<phone number> dial |
| sequence. |
|
|
The modem cannot | A pause in dialing may be needed to |
make a call when | allow time to connect to the outside |
connected to a PBX. | PSTN line. An example of dialing an |
| outside line is shown below, where a 9 is |
| used to access the outside line and a |
| comma causes a pause in the dialing |
| sequence. |
| $7' |
| The value of register S8 may be |
| adjusted to give the required delay, or |
| use a W in place of a comma. The W |
| causes the modem to wait for a second |
| dial tone before continuing and may |
| result in faster dialing. |
|
|
22 Sportster Winmodem 33600 & x2/56K - User's manual
