Connecting up and putting into operation

Tuning UHF channel / Checking operation

Switch on the satellite receiver via the on/off switch on the front of the unit. The LED display on the unit shows the last programme slot that was selected.

Turn on your TV set.

Tune in an AV programme channel on your TV set if the satellite receiver and TV set are connected by a Scart cable.

If the UHF connection is via a coax cable, tune in channel 38 to an empty pro- gramme slot on the TV set (receiver‘s default channel).

Also take note of any instructions in the TV set‘s operating manual!

Note

If channel 38 is occupied by a terrestrially broadcast programme or the video re-

 

corder, adjust your TV set to a spare UHF channel in the range 21 to 69.

 

To avoid interference, when setting the UHF output channel try to ensure that

 

there is at least one free channel above and below the channel.

 

For tuning of UHF output channel at the satellite receiver refer to "Modulator" in

 

section: "Initial setting".

 

You can now receive the factory-preset TV and radio programmes. To find out how

 

to tune in additional TV and radio programmes, refer to sections: “Programming TV

 

programmes“ and “Programming radio programmes“.

External infrared sensor

 

If the receiver is to be operated from a location that cannot be reached using the

 

remote control handset, (with attachment of a further stereo system in another

 

room, for example), the URS 200 external infrared sensor can be connected up via

 

the data copy I/O connection (Western modular 8-way). You can then also control

 

the receiver from the other room.

Important

All figures in this manual refer to the on-screen display in German. How to

 

select the OSD in English is described on page 24.

9

Page 9
Image 9
Kathrein UFD 400 manual Tuning UHF channel / Checking operation, External infrared sensor