Omnimount OM10064, 4N1-M manual For Hole Patterns Larger than 200mm x 200mm, TOP View, P22

Page 22

FOR HOLE PATTERNS LARGER THAN 200mm x 200mm

TOP VIEW

OPTION 1 - FRONT VIEW - 200mm x 400mm

P-C

400mm

P-D P-E

200mm

11

OPTION 2 – FRONT VIEW – 400mm x 400mm – 300mm x 300mm

400mm

300mm

300mm 400mm

P22

Image 22

Contents Maximum screen size Images may differ from actual product¡ADVERTENCIA! Español WARNUNG! Deutsch FIGYELEM! Magyar AVERTISMENT! Română ﺞﺘﻨﻤﻟﺎﺑ صﺎﺨﻟا نزﻮﻠﻟ ﻰﺼﻗﻷا ﺪﺤﻟا زوﺎﺠﺘﺗ ﻻ ΠΡΟΕΙΔΟΠΟΙΗΣΗ! ΕλληνικaSymbol KEY 水平调整水平器ハンマーオプションRemove Tighten Fastener Loosen Fastener Hand tighten Weight Capacity Maximum Screen SizeContents Tools P11取り外し StepP12 Allen WrenchScrew P13Bracket P14 Wood Stud InstallationGood Find stud and mark edge and center locationsP15 ウォールプレートを使って、取り付け場所に印を付けます。木製スタッドの壁への取り付け Wood Pilot Pilot Hole Size Pilot Drill DepthP16 Drill pilot holeConcrete Installation P17混凝土墙安装 Masonry Pilot Pilot Hole Size Pilot Drill LengthSolid Concrete Only Do Not Drill Into Mortar コンクリート壁への取り付けTop P19重要提示安装墙板注意：如果螺钉已拧到底，请使用垫圈（未提供）进行紧固 P21 SpacersSpacer Washer Not Included M-FOption 1 Front View 200mm x 400mm For Hole Patterns Larger than 200mm x 200mmTOP View Option 2 Front View 400mm x 400mm 300mm x 300mmOption 1 Back View Option 2 -BACK View Attach monitor using monitor hardware, M-A, M-B, etc…P23 For Hole Patterns 200mm x 200mm and Smaller M-F Attach monitor using monitor hardware, M-A, M-B, etc…P24 安装螺钉 P25モニタを取り付けた状態で掛けます。ネジを取り付けます。P26 Cable Management好みの位置または傾斜角度に調整します。 P27调整到合适的位置或倾斜度固定倾斜位置スウィベルを調整します。 P28调整旋转架水平调整P29 Left Blank IntentionallyLeft Blank Intentionally Omnimount Product Warranty P30P31 Applicable您购买 Omnimount 产品 P32