Woods Equipment MAN0063 manual Attach Side Rails to Rear Mounts & Front Support, Torque Hardware

LOADER MOUNT INSTALLATION Cont’d

Attach Side Rails to Rear Mounts & Front Support

1.Attach side rail to inside of right rear mount, using four carriage bolts (12), flat washers (14), and hex nuts (10) as shown in Figure 5.

2.Attach side rail to outside of front support, using two cap screws (12), flat washers (14), and nuts (10) as shown in Figure 6.

3.Repeat Step 1 and Step 2 to install left side rail to left rear mount.

10.230 5/8 Hex nut

12. 301130 5/8 1-1/2 Carriage bolt

14.57817 5/8 Hardened flat washer

Torque Hardware

1.Torque all hardware to specifications given below.

12 14 10

Figure 5 Side Rail Installed to Right Rear Mount

12 14 10

Figure 6 Side Rail Installed to Front Mount

TORQUE SPECIFICATIONS
		Wrench
Bolt	Qty	Size	Required Torque
3/4 NC x 1-3/4 HH cap screw	12	1-1/8”	297 lbs.-ft. (403 N-m)
3/4 NC x 2 HH cap screw	8	1-1/8”	297 lbs.-ft. (403 N-m)
5/8 x 1-1/2 Carriage bolt	12	15/16”	170 lbs.-ft. (230 N-m)

10 Mount Installation

(Rev. 1/25/02)

MAN0063 (12/15/00)