Samsung SV-262B, SV-661I, SV-265B, SV-261B, SV-662B, SV-661B, SV-261I By means of RF Coaxial Cable

Page 7

Connecting Your VCR to the TV using the Coaxial Cable and SCART cable

GB

Connecting Your VCR to the Satellite receiver or Other Equipment

GB

TV

2

AV1 (EURO

TV

TV

AV1 (EURO AV)

3

4

TV

AV1 (EURO AV)

5

To receive television programmes a signal must be received from one of the following sources:

◆An outdoor aerial

◆An indoor aerial

◆A cable television network

◆A satellite receiver

☛Make sure that both the television and the VCR are switched off before connecting the cables.

1Remove the aerial or network input cable from the television.

2Connect this cable to the 75Ω coaxial socket marked on the rear of your VCR.

3

Plug the coaxial cable supplied into the

TV

socket on your VCR.

 

4Plug the other end of the coaxial cable into the connector previously used for the aerial on the television.

5Connect one end of the scart cable to the AV1 (EURO AV) socket on the rear of the VCR. You must connect your VCR to the television via the scart cable.

6Plug the other end into the appropriate connector on the television.

You can connect your VCR to a Satellite receiver or other VCR using the SCART cable if the appropriate outputs are available on the equipment chosen. The following illustrations give a few examples of the connection possibilities.

1. AV2(SATELLITE): By means of 21-pin Scart Cable ★(SV-665B/SV-661B/SV-662B/SV-661I Only)

Plug the SCART Cable with satellite receiver or other equipment into the AV2(SATELLITE) socket on the rear of the VCR.

After making this connection, select the source by pressing the INPUT button for the AV2 input sources.

2. By means of RF Coaxial Cable

After making this connection, you must preset the station received through the satellite tuner.

RF output channel of the satellite receiver should be adjusted away from channel 60, which is used by the VCR, e.g. re-adjust to channel 65.

Aerial

Satellite Receiver or other Equipment

Aerial Connector

2

SCART Cable

TV

1

AV2 (SATELLITE) IN

TV

AV1 (EURO AV)

SCART Cable

12

13

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Video Cassette Recorder Safety Precautions About this manual Contents SymbolsIt in a cool, dry place Safety InstructionsFront View of the VCR Mains socket and aerialRear View of the VCR Infrared Remote ControlConnector Location Type Display IndicatorsAccessories Deciding How to Connect Your VCRBy means of RF Coaxial Cable Channel Connecting the Audio Output Cable SV-665B/SV-661BTuning Your Television for the VCR Plug & Auto Set UpDisplay on-screen information On is displayed Setting the Date and TimeSetting the VCR Output Channel Press or ❿, untilIf you Then 11 To...ThenCLR/RST Menu Clearing a Preset Station Changing the Preset Station TableMenu TV Station Table Selecting the Recording Speed Selecting the Cassette TypeRecording a Programme Immediately If you wish to Then Modifying VIDEOPLUS+ Programming 665B/SV-265B OnlyCancelling a Preset Recording Eject Adjusting Picture Alignment ManuallyPlaying a Cassette Intelligent Picture Control Then pressSelecting the Colour Mode To return to normal playback, press ❿ ll Picture Search, Fast Forward/RewindInterval Repeat Play Searching for a Specific Sequence Auto Repeat PlayPress ❿, until Insert a cassette in your VCR Using the Tape CounterBrand Codes Recording from Another VCR or CamcorderButton Function SV-662B/SV-661I Auto Power Off Technical SpecificationsECO Mode-Reducing Standby power consumption SV-665B/SV-661BProblem Explanation/Solution Problems and SolutionsTuner Warranty Conditions Electronics Warranty CardThis Appliance is Distributed by
Top Page Image Contents