Emerson EWC19T5 Times Display Recording length, You can not copy a DVD to a videotape, Sp/Slp

OTR (One Touch Recording)

TV/VCR

This function enables you to set a recording length simply by hitting [REC/OTR] on the unit.

Make sure ...

•The unit must be turned on.

•Insert a cassette tape with its erase-prevention tab in place. (If necessary, rewind or fast forward the tape to the point at which you want to begin recording.)

NOTES:

•You cannot start OTR with the remote control.

•Recording starts immediately when [REC/OTR] is hit.

•When [REC/OTR] is hit 18 times, the unit returns to the normal recording mode.

•To stop the OTR operation, hit [C STOP] on the unit or on the remote control.

Time(s)	Display	Recording length
1 time		(normal recording)
2 times	0:30	30 minutes
3 times	1:00	60 minutes
17 times	8:00	480 minutes

COPYING A VIDEO CASSETTE (Requires a VCR or camcorder)

TV/VCR

You can make copies of video tapes made by friends or relatives for your enjoyment.

You can not copy a DVD to a videotape.

WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws.

• To show the remaining time, hit [DISPLAY] on	Connect your unit and a source (Playing) VCR using
the remote control so that “OTR” appears on the	the following diagram.
TV screen. (It will show up momentarily then dis-	[This unit]		[Fig.8]
appear.)
• Recording stops when the display shows 0:00.	AY F.FWD STOP/EJECT
	HEADPHONE VIDEO	L AUDIO R
• Please note that in the SLP mode maximum
recording time, assuming the tape is started at the
beginning, is 8 hours using T-160 (or 6 hours
using T-120).
• If the tape runs out before the end time, the unit		[Ex: Source VCR or
will switch to the stop mode immediately, ejects
		camcorder]
the tape and turns itself off.	Audio/Video
• Even if [POWER] is hit during OTR, the unit		AUDIO
	cable	OUT	IN
		L
continues recording.	(not supplied)	R
		VIDEO
		OUT	IN

1Select the channel to be recorded

Press the Number buttons or [CH. K / L].			1)Insert a pre-recorded video cassette into the source
			VCR or camcorder.
NOTE:
			2)Insert a blank video cassette or one you want to
• If the unit is connected to a cable box or satellite
			record over, into the unit’s cassette compartment.
box, the unit must be on CH3 or CH4, then the			3)Hit	[SPEED] on remote control for the unit to
channel to be recorded is selected on the cable box
			select the desired recording speed (SP/SLP).
or satellite box.
			4)Press [CHANNEL K / L] on the unit until “AUX”
			appears on the screen.
2 Select the tape speed
			5)Hit [REC/OTR] on the unit.
Hit [SPEED] to select the desired tape speed			6)Begin playback of the tape in the source VCR or
(SP/SLP).			camcorder.
			NOTE:
			• For best results during copying, use the front
3 Begin OTR
			panel controls whenever possible. The remote
Hit [REC/OTR] on the unit as
	OTR (2 : 30)		control might affect the source VCR’s playback
many times as needed. The record-
			operation.
ing length will be determined by
			7)To stop copying, hit [C A STOP/EJECT] on the
the number of times you hit
			unit, then stop the tape on the source VCR or cam-
[REC/OTR]. Each time it is hit,
	SP		corder.
the recording time will be increased
by 30 minutes up to 8 hours.
		- 29 -		EN