Panasonic PV C923 Damage Requiring Service, Replacement Parts, Safety Check, Heat

Page 4

IMPORTANT SAFEGUARDS

19.DAMAGE REQUIRING SERVICE

Unplug this unit from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power-supply cord or plug is damaged.

b.If liquid has been spilled, or objects have fallen into the unit.

c.If the unit has been exposed to rain or water.

d.If the unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operat- ing instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the unit to its normal operation.

e.If the unit has been dropped or the cabinet has

been damaged.

f . When the unit exhibits a distinct change in performance, this indicates a need for service.

20.REPLACEMENT PARTS

When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part.

Unauthorized substitutions may result in fire, electric shock or other hazards.

21.SAFETY CHECK

Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition.

22.HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

23.NOTE TO CATV SYSTEM INSTALLER

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

EXAMPLE OF ANTENNA GROUNDING AS PER THE

NATIONAL ELECTRICAL CODE

ANTENNA LEAD IN WIRE

GROUND CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

ELECTRIC SERVICE

EQUIPMENT GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

NEC-NATIONAL ELECTRICAL CODE

 

POWER SERVICE GROUNDING

 

S2898A

 

 

ELECTRODE SYSTEM

 

 

(NEC ART 250, PART H)

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Combination VCR Operating Instructions Model No. PV-C923 Cleaning Read InstructionsRetain Instructions Heed WarningsPower Sources POWER-CORD ProtectionPower Lines VentilationDamage Requiring Service Replacement PartsSafety Check HeatSafety Precautions Install the TV/VCR in Your CARWhen YOU Experience the Above CONDI- Tions Moisture CondensationDriving Safety FeaturesImportant Notes Table of Contents Location of Controls Front RearDescription of Controls Cassette Loading Slot To insert or remove a video tapeRemote Control Counter Reset Button Used to reset the counter toRemote Control Power Sources Battery InstallationBattery Precautions Effective Distance of the Remote ControlAntenna Connections Replacing the Fuse in the CAR Battery Cord PlugPlug 8A Fuse TIP Setting the Language For Subscribers to Basic Cable TV ServiceFor Subscribers to Scrambled Cable TV Service Cable TV ConnectionsAuto Clock Setting Manual Clock Setting TV mode direct channel selectionCatv mode direct channel selection To Select Catv ChannelsMute ChannelDisplay SleepAutomatic Memory Tuning TV Operation To Memorize ChannelsTV/CATV Selection CatvSetting the V-CHIP To Register the PasswordTo ADD/DELETE Channels To SET the V-CHIPTo SET the on Timer To Change PasswordTo SET the OFF Timer Picture Control AdjustmentsPlayback Special Playback ONE-TOUCH Timer Recording OTR Timer RecordingUsing the Real Time Tape Counter Using Zero SearchConnection to Another VCR Duplicating a Video TapeConnection to Camcorder Video Head Cleaning Reception DisturbancesTroubleshooting Guide Symptom Cause Possible Solution PowerOperate Heads Two or three hours until it goes off TV Broadcast ReceptionSymptom Cause Possible Solution Remote ControlRecording PlaybackSpecifications AccessoriesTelevision VCRRemote Control Button Index of ControlsVolume + Channel C/D RECFirst EjectVHF Conexiones DE LA Antena Conexiones DE TV CableUHF VHF Power Seleccion DE Idioma EN Pantalla Ajuste DE Reloj ManualAjuste DE Reloj Automatico Reajuste DEL Reloj AutomaticoSeleccion DE TV/CATV Colocacion ExtraccionInicio DE LA Reproduccion Rebobinado O Avance Rapido DE LA CintaGrabacion DE UN Programa DE TV Parada DE GrabacionParada Temporaria DE Grabacion Presione el botón REC/OTRMemo Product Parts Labor Service Contact Number Limited Warranty CoverageCarry-In, Mail-in or In-Home Service Limited Warranty Limits And Exclusions As of AugustIndex Safety PrecautionsLocation of Controls Page One Panasonic Way Secaucus New Jersey
Top Page Image Contents