Panasonic PV C923 operating instructions Location of Controls, Front Rear, Description of Controls

Page 8

LOCATION OF CONTROLS

FRONT

REAR

20

1

 

VIDEO

UHF/

AUDIO

VHF

OUT

LINE1

2

 

3 4

5

6

 

 

7

8

16

17

18

19

POWER

POWER PROG TIMER

REC

 

 

 

 

 

 

 

 

 

 

VOL

CH

REC STOP/EJECT

PLAY

REW/

FF/

 

 

 

 

 

9

10

11

12

 

13

14

 

 

15

 

 

 

DESCRIPTION OF CONTROLS

FRONT:

1.Cassette Loading Slot - To insert or remove a video tape.

2.POWER Button - Press to turn the TV/VCR on or off.

3.POWER Indicator - Light when the power is turned on.

4.PROG TIMER Indicator - Lights when the unit is in the Timer Record Mode.

5.REC Indicator - Lights when the TV/VCR is recording.

6.STOP/EJECT Button - Press once to stop the tape in any mode. Press again to eject the tape.

7.FF (Fast Forward) Button - In the Stop mode, this button rapidly winds the tape forward. In the Play mode, this button activates forward search.

8.PHONES Jacks - Plug monaural headphones or an earphone with an 1/8" miniplug into these jacks for private listening. Two persons can be able to use these jacks at the same time.

9.Remote Sensor - Signals from the Remote Control are received here.

10.VOL – / + Buttons -Press to raise or lower the volume of the sound.

11.CH / Buttons - Press to select a channel for viewing or recording.

12.REC Button - Press once to start normal recording. Additional presses activate One-touch Timer Recording.

13.PLAY Button - Press to play a prerecorded tape.

14.REW (Rewind) Button - In the Stop mode, this button rapidly winds the tape backwards. In the Play mode, this button activates reverse search.

15.Audio/Video In (LINE 2) Jacks - Audio and video signal cables from an external source can be connected here.

REAR:

16.VHF/UHF Antenna Jack - Connect the 75 ohm coaxial cable from the antenna or Cable TV service to this jack.

17.AUDIO/VIDEO OUT Jacks - Used to output audio and video signals to a TV, amplifier or VCR.

18.AUDIO/VIDEO IN (LINE 1) Jacks - Audio and video signal cables from an external source can be connected here.

19.AC Power Cord - Connect to a 120V, 60Hz outlet.

20.DC Input Jack - Connect the 12V DC car cord (supplied) here for DC operation.

8

Image 8
Contents Combination VCR Operating Instructions Model No. PV-C923 Cleaning Read InstructionsRetain Instructions Heed WarningsPower Sources POWER-CORD ProtectionPower Lines VentilationDamage Requiring Service Replacement PartsSafety Check HeatSafety Precautions Install the TV/VCR in Your CARWhen YOU Experience the Above CONDI- Tions Moisture CondensationImportant Notes FeaturesDriving Safety Table of Contents Location of Controls Front RearDescription of Controls Cassette Loading Slot To insert or remove a video tapeRemote Control Counter Reset Button Used to reset the counter toRemote Control Power Sources Battery InstallationBattery Precautions Effective Distance of the Remote ControlPlug 8A Fuse TIP Replacing the Fuse in the CAR Battery Cord PlugAntenna Connections Setting the Language For Subscribers to Basic Cable TV ServiceFor Subscribers to Scrambled Cable TV Service Cable TV ConnectionsAuto Clock Setting Manual Clock Setting TV mode direct channel selectionCatv mode direct channel selection To Select Catv ChannelsMute ChannelDisplay SleepAutomatic Memory Tuning TV Operation To Memorize ChannelsTV/CATV Selection CatvSetting the V-CHIP To Register the PasswordTo ADD/DELETE Channels To SET the V-CHIPTo SET the on Timer To Change PasswordTo SET the OFF Timer Picture Control AdjustmentsPlayback Special Playback ONE-TOUCH Timer Recording OTR Timer RecordingUsing the Real Time Tape Counter Using Zero SearchConnection to Camcorder Duplicating a Video TapeConnection to Another VCR Video Head Cleaning Reception DisturbancesTroubleshooting Guide Symptom Cause Possible Solution PowerOperate Heads Two or three hours until it goes off TV Broadcast ReceptionSymptom Cause Possible Solution Remote ControlRecording PlaybackSpecifications AccessoriesTelevision VCRRemote Control Button Index of ControlsVolume + Channel C/D RECFirst EjectUHF VHF Conexiones DE LA Antena Conexiones DE TV CableVHF Power Seleccion DE Idioma EN Pantalla Ajuste DE Reloj ManualAjuste DE Reloj Automatico Reajuste DEL Reloj AutomaticoSeleccion DE TV/CATV Colocacion ExtraccionInicio DE LA Reproduccion Rebobinado O Avance Rapido DE LA CintaGrabacion DE UN Programa DE TV Parada DE GrabacionParada Temporaria DE Grabacion Presione el botón REC/OTRMemo Carry-In, Mail-in or In-Home Service Limited Warranty CoverageProduct Parts Labor Service Contact Number Limited Warranty Limits And Exclusions As of AugustLocation of Controls Safety PrecautionsIndex Page One Panasonic Way Secaucus New Jersey