Magnavox CC13B1MG owner manual Helpful Hints

Page 54

54 Helpful Hints

If you are having problems with your product, check this list of problems and possible solutions before requesting service. You may be able to solve the problem yourself.

If you need to call a customer service representative, please know the model number and serial number of your product before you call. This information is displayed on the back of the product. Also, please take a moment to identify the problem you are having, and be prepared to explain this to the representa- tive. If you believe the representative will need to help you with operations, please stay near the product. Our representatives will be happy to assist you.

Location

For safe operation and satisfactory performance of your TV/VCR, remember the following:

Shield it from direct sunlight and keep it away from sources of intense heat.

Avoid dusty or humid places.

Avoid places with insufficient ventilation. Do not block the ventilation openings at the top and bottom of the TV/VCR. Do not place the TV/VCR on a carpet, as this will block the ventilation openings.

Avoid locations subject to strong vibrations.

Do not place the TV/VCR near strong magnetic fields.

Do not move the TV/VCR from a cold place to a hot place, or vice versa.

Electrical Shock and Fire Hazards

Do not handle the power cord with wet hands.

Do not pull the power cord when disconnecting the TV/VCR from the AC (alternating current) wall out- let. Grasp it by the plug.

If water is spilled on the TV/VCR, unplug the power cord immediately and take the TV/VCR to an autho- rized service center.

Do not put your fingers or objects into the TV/VCR cassette compartment.

Do not place anything on top of the TV/VCR.

Dew Warning (Moisture Condensation)

Moisture may condense inside the unit when it is moved from a cold place to a warm place, after heating a cold room, or when the humidity is high. There is no warning that moisture has accumulated in your TV/VCR. If you try to play a tape in a TV/VCR in which moisture has accumulated, the tape and the TV/VCR could be damaged. If you think moisture may have accumulated inside the TV/VCR, keep the TV/VCR power on (but do not play a tape) for at least two hours. This will allow the TV/VCR to dry.

TV/VCR will not perform a timer recording.

Make sure the recording start and stop times are set correctly. Details are on pages 32-35.Midnight is 12 a.m. Noon is 12 p.m.

Make sure the TV/VCR power is off.

Make sure the clock is set. Details are on pages 12-17.

Make sure there is a tape in the TV/VCR. The tape must have a record tab.

With ShowGuard, you don’t have to worry about losing your timer recordings. If the power fails, pro- grammed timer recordings will be restored when the clock is reset. (The clock will reset itself automati- cally if you are using the AUTO CLOCK feature. Details are on pages 14-17.If you are not using the AUTO CLOCK feature, reset the clock manually. Details are on pages 12-13.) The timer recording will not occur only if the timer recording was scheduled to take place during the power failure.

Make sure DEFEAT RECORDING is set to OFF. Details are on page 36.

TV/VCR will not record.

Make sure the tape has a record tab. Details are on page five.

Make sure DEFEAT RECORDING is set to OFF. Details are on page 36.

Plug the power cord into an active AC outlet. Details are on page seven.

Check your hookups. Details are on pages six-seven.

Set up the channels. Details are on page 10.

TV/VCR has no power.

• Make sure the power plug is completely connected to an AC (alternating current) outlet.

Image 54
Contents Tvcr Warranty Verification For Customer UseIntroduction FeaturesSafety Precautions Declaration of ConformityTable of Contents TV/VCR Maintenance Putting Batteries in the Remote ControlUsing the Remote Control Recording PreventionHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Hooking Up the TV/VCR cont’d Crooked Pin Straight PinYou cannot set up channels if you are using a Cable Box Turning On the TV/VCRLanguage Selection Press the Menu buttonAutomatic Channel Setup Adding/Deleting Channels Press the PLAY/ button or the STOP/ button to selectSetting the Clock Manual Clock SettingCable Box users must set the clock manually Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’d Manual PBS Channel Selection Use the Number buttons to select your PBS station Daylight-Savings Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons ALT. CH Alternate Channel Button Channel / ButtonsMemory Button SLEEP/WAKE UP ButtonAdjusting the Picture Controls Adjusting the Picture Controls cont’d Decrease IncreaseIf you select Status ON, then select Counter only on On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status OFFReminder ReminderPlaying VHS Quasi Play Back SqpbRecording To stop recording, press the STOP/ button Tape SpeedsOne-Touch Recording Press the RECord/OTR button repeatedly until the desiredRerecording Tape Duplication Different brands of equipment may operate differentlyTimer Recording DailyTimer Recording cont’d Timer Recording cont’d 1110Checking or Clearing Timer Recordings Defeat Recording REC DefeatedRepeat Play B Repeat Play Insert a tape in the TV/VCR Press the Menu buttonRepeat Play cont’d Press the STATUS/EXIT button to remove the menu. A-BReal-Time Counter Memory Super High Speed Searching LP/SLP Playback OptionsForward and Reverse Searching SP/LP/SLP Viewing a Still PictureEnter Your Access Code SmartLockSmartLock cont’d Example Specific Sub-ratingsTo change the access code, follow these steps Rating Explanations Wake Up Timer Press the SLEEP/WAKE UP buttonSleep Timer Menu Closed CaptionExample ScreenClosed Caption cont’d Standard Closed CaptionsBlue Background Volume Bar Automatic Operation Features Specifications Helpful Hints Helpful Hints cont’d Glossary Renewed Index MemoryPage Supplied Accessories