Magnavox CC13B1MG owner manual Timer Recording cont’d

Page 33

Timer Recording (cont’d) 33

4

Use the Number buttons (1-8) to select a position in which to store the timer recording. Flashing numbers indi- cate an open position (one in which a timer recording has not been stored yet).

NOTE: If you select a number that already has been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on the screen for a few seconds. Then information about the program in that position will appear on the screen. If this happens, press the STATUS/EXIT but- ton. Then use the Number buttons to select another position.

5

Use the Number buttons to enter the channel of the TV program you want to record.

4-7

POWER MENU STATUS/EXIT CLEAR

1 2 3 MEMORY

4 5 6

7 8 9 CHANNEL

●If you are recording from line input, press 0, 0. A/V IN will appear on the screen.

●If you are recording using a Cable Box, enter the Cable Box output channel (03 or 04). Be sure to select the channel of the TV program at the Cable Box and leave the Cable Box on for the timer recording.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL – – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

6

Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL

10

TIME ON

– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

7

Follow the instructions in step 6 to set the recording’s stop time. (AM or PM will be set automatically.)

ONE TIME PROGRAM

PROGRAM 1

CHANNEL

10

TIME ON

09:30 PM

TIME OFF

– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Instructions continue on page 34.

0ALT.CH

SLEEP/WAKE UP

VOLUME

MUTE

SPEED

REW/SEARCH PLAY/ FF/SEARCH

REC/OTR STOP/ PAUSE/STILL

Helpful Hints

•If the numbers entered do not match the TV/VCR’s clock or calen- dar, the entry will be rejected and a question mark will appear on the screen.

•To make corrections while you are programming a timer recording, press the CLEAR button until the item you want to change starts flashing. Then enter the correct information.

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Tvcr For Customer Use Warranty VerificationSafety Precautions FeaturesIntroduction Declaration of ConformityTable of Contents Using the Remote Control Putting Batteries in the Remote ControlTV/VCR Maintenance Recording PreventionHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Crooked Pin Straight Pin Hooking Up the TV/VCR cont’dTurning On the TV/VCR You cannot set up channels if you are using a Cable BoxPress the Menu button Language SelectionAutomatic Channel Setup Press the PLAY/ button or the STOP/ button to select Adding/Deleting ChannelsSetting the Clock Manual Clock SettingCable Box users must set the clock manually Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’d Manual PBS Channel Selection Use the Number buttons to select your PBS station Daylight-Savings Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons Memory Button Channel / ButtonsALT. CH Alternate Channel Button SLEEP/WAKE UP ButtonAdjusting the Picture Controls Decrease Increase Adjusting the Picture Controls cont’dIf you select Status ON, then select Counter only OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status OFFReminder ReminderVHS Quasi Play Back Sqpb PlayingTo stop recording, press the STOP/ button Tape Speeds RecordingPress the RECord/OTR button repeatedly until the desired One-Touch RecordingDifferent brands of equipment may operate differently Rerecording Tape DuplicationDaily Timer RecordingTimer Recording cont’d 1110 Timer Recording cont’dChecking or Clearing Timer Recordings REC Defeated Defeat RecordingRepeat Play Insert a tape in the TV/VCR Press the Menu button B Repeat PlayPress the STATUS/EXIT button to remove the menu. A-B Repeat Play cont’dReal-Time Counter Memory Forward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still PictureSmartLock Enter Your Access CodeExample Specific Sub-ratings SmartLock cont’dTo change the access code, follow these steps Rating Explanations Press the SLEEP/WAKE UP button Wake Up TimerSleep Timer Example Closed CaptionMenu ScreenStandard Closed Captions Closed Caption cont’dBlue Background Volume Bar Automatic Operation Features Specifications Helpful Hints Helpful Hints cont’d Glossary Renewed Memory IndexPage Supplied Accessories
Top Page Image Contents