Magnavox CC13B1MG Hooking Up the TV/VCR, Hook up your TV/VCR using one of the connections shown

Page 6

6 Hooking Up the TV/VCR

1

Hook up your TV/VCR using one of the connections shown.

A.

Hooking Up Your TV/VCR With a Cable Signal or Outdoor Antenna

Connect a Cable signal or an antenna to the ANT(enna) Jack.

ANT.

ANT.

B.

Hooking Up Your TV/VCR With a Cable Box

To view any channel, set the TV/VCR to the Cable Box output channel (channel 03 or 04). Then, select channels at the Cable Box.

C.

Hooking Up Your TV/VCR With an Indoor Antenna

To install a rod antenna (not sup- plied), push the stem of the antenna into the antenna hole on the top of the TV/VCR. Connect the antenna wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.

Connect the Cable signal to the IN Jack on the Cable Box.

Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT Jack
on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.	OUT	IN

RF coaxial cable

(not supplied)

ANT.

ANT.

Rod Antenna

(not supplied)

ANT.

ANT.

Image 6

Contents Tvcr Warranty Verification For Customer UseIntroduction FeaturesSafety Precautions Declaration of ConformityTable of Contents TV/VCR Maintenance Putting Batteries in the Remote ControlUsing the Remote Control Recording PreventionHook up your TV/VCR using one of the connections shown Hooking Up the TV/VCRRod Antenna Hooking Up the TV/VCR cont’d Crooked Pin Straight PinYou cannot set up channels if you are using a Cable Box Turning On the TV/VCRLanguage Selection Press the Menu buttonAutomatic Channel Setup Adding/Deleting Channels Press the PLAY/ button or the STOP/ button to selectSetting the Clock Manual Clock SettingCable Box users must set the clock manually Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’d Manual PBS Channel Selection Use the Number buttons to select your PBS station Daylight-Savings Time Time Zone Front Panel AC Power Cord Rear PanelANTenna Jack Remote Control Buttons ALT. CH Alternate Channel Button Channel / ButtonsMemory Button SLEEP/WAKE UP ButtonAdjusting the Picture Controls Adjusting the Picture Controls cont’d Decrease IncreaseIf you select Status ON, then select Counter only on On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status OFFReminder ReminderPlaying VHS Quasi Play Back SqpbRecording To stop recording, press the STOP/ button Tape SpeedsOne-Touch Recording Press the RECord/OTR button repeatedly until the desiredRerecording Tape Duplication Different brands of equipment may operate differentlyTimer Recording DailyTimer Recording cont’d Timer Recording cont’d 1110Checking or Clearing Timer Recordings Defeat Recording REC DefeatedRepeat Play B Repeat Play Insert a tape in the TV/VCR Press the Menu buttonRepeat Play cont’d Press the STATUS/EXIT button to remove the menu. A-BReal-Time Counter Memory Super High Speed Searching LP/SLP Playback OptionsForward and Reverse Searching SP/LP/SLP Viewing a Still PictureEnter Your Access Code SmartLockSmartLock cont’d Example Specific Sub-ratingsTo change the access code, follow these steps Rating Explanations Wake Up Timer Press the SLEEP/WAKE UP buttonSleep Timer Menu Closed CaptionExample ScreenClosed Caption cont’d Standard Closed CaptionsBlue Background Volume Bar Automatic Operation Features Specifications Helpful Hints Helpful Hints cont’d Glossary Renewed Index MemoryPage Supplied Accessories