Toshiba SD-V392SU manual To wall outlet, Component video

S-video output/input

An S-Video connection is superior to Video (Yellow) output. Use this method for DVD playback when the connected television has S- Video input, and does not have component video inputs.

Component video outputs/inputs

PROGRESSIVE outputs/inputs

Some TVs or monitors are equipped with component video inputs that are capable of reproducing a progressively scanned video signal. Connecting to these inputs allows you to view the highest quality pictures with less flicker.

INTERLACED outputs/inputs

Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy the highest quality DVD picture playback.

Notes:

•Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR)

•In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In such a case, adjust the TV or monitor for optimum performance.

Connecting to an audio system and TV equipped with S-video input/component video inputs

Note: The S-video output and component video output transports the DVD-video signal exclusively and will deliver enhanced DVD video picture performance.

Signal flow

Connections

(white)	To ANALOG
	AUDIO OUT
(red)

To wall outlet

To S-	To PR/CR	To PB/CB	To Y
VIDEO	VIDEO	VIDEO	VIDEO
OUT	OUT	OUT	OUT

When you make this connection, set the S-VIDEO/ COMPONENT Video selector switch to the desired position.

And also you must select the corresponding video input on your TV.

Component video	Audio cable (not supplied)
cable (not supplied)	To audio inputs of
To Y video input	the amplifier
	(red)	(white)

To PB/CB video input

To PR/CR video input

To S-video input

S-video cable (not supplied)

If you connect the DVD/VCR to your TV with the DVD OUT jacks, select the corresponding video input on your television to watch DVD video discs.

TV or monitor with	Audio system
ColorStream®
component video inputs

Notes:

•Refer to the owner’s manual of the connected equipment as well.

•When you connect the DVD/VCR to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.

•If you place the DVD/VCR near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD/ VCR away from the tuner and radio.

•The output sound of the DVD/VCR has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.

•Turn off the amplifier before you connect or disconnect the DVD/VCR’s power cord. If you leave the amplifier power on, the speakers may be damaged.

•When connecting to a TV using the Video or S-video jack, make sure that the Progressive indicator “” on the display window is not lit. If it is lit, the Video and S-video outputs do not feed the correct signals and you cannot see any picture. To turn off the Progressive indicator, select PROGRESSIVE scan Off (see page 66).

19

2C53301C (E)p18-25 19

21/4/04, 11:10