Toshiba SD-V392SU manual Battery precautions, Operation

Page 13

Inserting batteries

Slide the battery compartment

Install two “R03/AAA” batteries

3

Replace the compartment

cover in the direction of the

(supplied), paying attention to the

cover.

1 arrow.

2 polarity diagram in the battery

 

compartment.

Battery precautions

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re- versed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

Introduction

Remote control basics

Press POWER ( ) to turn the DVD VCR on or off.

Select your desired operating mode (DVD or VCR) using VCR DVD.

(DVD or VCR indicator on the front panel will show you which mode is selected.)

Press CH + or CH – to move through the channels one channel at a time.

The CH +/( / ) and SET +/–( /) are also used to navigate on-screen menu system.

You can directly access specific channels using Number buttons.

Each press of VCR DVD on the remote control, switches the screen between the VCR screen (VCR mode) and the DVD screen (DVD mode).

Operation

 

• Aim the remote control at the remote sensor and press control buttons to

 

operate.

 

• Operate the remote control within 30° angle on either side of the remote

Approx. 7 meters

sensor, up to a distance of Approx. 7 meters.

13

2C53301C (E)p02-13

13

21/4/04, 11:09

Image 13
Contents Toshiba Corporation SD-V392SULocation of the required Marking IntroductionIntroduction S3125AHeat LightningS2898A DiscDo not use the DVD/VCR when moisture condensation may occur PrecautionsTo obtain a clear picture WaiOn handling discs On cleaning discs Structure of disc contentsOn storing discs Playable discs On Video CDsDVD Contents Front panel Identification of controlsRear panel VCR operation status Display windowDVD/CD/VCD operation status While watching TV While operating a tapeSkip Remote controlOperation Battery precautionsAntenna to DVD/VCR connection Antenna connectionsConnections DVD/VCRDVD/VCR to TV connection Set the TV/CATV menu option to TV modeConnections Ohm Coaxial Cable suppliedCatv Cable TV connections Splitter SwitchIncoming Cable Converter/Descrambler Converter/Descrambler SplitterConnecting to a TV Connecting to a TVComponent video To wall outletConnecting to an amplifier equipped with a DTS decoder Connecting to optional equipmentMPEG2 sound Use DVD video discs encoded via the MPEG2 recording systemSetting the video channel Setting the video channelBasic setup When a TV is connected with the 75 ohm coaxial cable onlySetting the language Setting the languageAuto Clock adjustment Clock settingTo set Auto Clock to off Press SET + or to select one To set Standard TimeEnter Manual clock settingSetting channels automatically Tuner settingTV/CATV selection Repeat left and press SET + or to select AUT O CH MemoryNoise elimination To ADD/DELETE channelsLoading Loading and unloading a cassette tapeUnloading To prevent accidental erasurePlayback Cassette tape playbackRewind or forward the tape Special playback Repeat playback Convenience functionZero return function Video index search system Clock/counter displaySqpb S-VHS Quasi Playback CounterRecording a TV program Recording a TV programRecording VCR VHF/UHF/CATV Channels CatvTo stop recording temporarily To stop recordingRecording one program while Watching another One-touch Timer Recording OTR One-touch Timer Recording OTRTo cancel OTR Set TV or CA TV option to the appropriate positionTimer recording Timer recordingTo confirm Timer program To confirm or cancel a programTo cancel Timer program If the programs overlap anotherSecond Audio Program SAP Stereo recording and playbackOther functions VCR Duplicating a video tape Duplicating a video tapeConnection with second VCR Connection with CamcorderDuplicating a DVD or CD disc Recording a DVD/CD discPress Play to start playback Press REC/OTR to start recordingPlaying a disc To start playback in the stop modeVcdcd Basic playback Basic playback DVDTo obtain a higher quality picture To pause playback still modeAbout To stop playbackVcddvd Playing frame by frame VCD Playing in fast reverse or fast forward directionsVcddvd Playing in slow-motion VCD Locating a chapter or trackMP3/WMA playback MP3/WMA/JPEG playbackAdvanced playback DVD MP3/WMA/JPEG CD InformationPress Jpeg CD playbackPress / or / to select the desired file File menu appears on the TVSetting the Jpeg Interval Press Enter or / to select your desired file type Setting the Select FilesAll Music OnlyChanging angles Jpeg CD Zooming Jpeg CDZooming/Locating desired scene CancelVcddvd Zooming VCD Locating desired sceneVcddvd Marking the scenes Marking desired scenesVcddvd Returning to the scenes VCD A-B Repeat playback Repeat playback/A-B Repeat playbackCD/VCD Vcdcd Program playback Program playback/Random playback CDVCD Random playback Changing angles Changing angles/Title selection/DVD menuTitle selection DVD menuFunction setup DVD VCD Setting surround soundDVD Changing soundtrack language During disc playback press AudioTurning the subtitles on and off Setting subtitles/Karaoke playbackChanging the subtitle language Karaoke playbackAdvanced playback DVD Function setup DVD Setting E.B.LL. Enhanced Black Level Press or ENTER, then press or to select E.B.LSetting the aspect ratio of TV screen Setting the aspect ratio of TV screenSetting on screen display Setting on screen display/Status display of discVcdcd Status display of disc Video CDPress or ENTER, then press or to select Desired setting Press Setup in the stop mode Press or to select SoundDynamic Range Control Dynamic Range ControlParental control setting Parental control settingEnter the correct password Function setup DVDPress Setup or Return To remove the parental control screen If you forget the passwordTo change the parental level To change the parental levelTemporary disabling of rating level by DVD disc Playback will commence if the entered Password was correctReturn VCD Setting OSD language Setting OSD languageSetup language can be selected Press or Enter to select OSD LanguageSetting language Setting languageVCD Selecting Progressive scan Selecting Progressive scanOthers Language code listSymptoms Possible Solutions DVD/VCR TroubleshootingSupplied accessories SpecificationsGeneral Input/OutputLimited warranty Others 04/03 U Precaucion Referencìa rápidaInstrucciones Importantes Ajuste del canal de video Conexión a un televisorSeleccion de idioma en pantalla Ajuste de reroj manual Ajuste de reloj automaticoSeleccion de TV/CATV Ajuste automático de los canalesCamara lenta ReproducciónAvance cuadro a cuadro Rebobinado o avance rápido de la cintaGrabacion por temporizador Para cancelar OTRReproducción con avance rápido Reproducción básica DVDReproducción con retroceso rápido Reproducción FijaFunciones básicas del control remoto Búsqueda de un capítulo o canciónColoque las pilas Notas sobre los derechos de autor