Toshiba HD-EP35KB manual Accessories, Remote control, Supplied accessories, Loading batteries

Page 12

Accessories

Supplied accessories

Check that the following accessories are supplied.

Remote control

Batteries (R03)

HDMI cable

Power cord

(For HD-EP35KB)

(For HD-EP35KE)

Caution

Do not use this power cord with any device other than this player.

Remote control

Loading batteries

1 Open the cover and load batteries (R03 size).

Make sure to match the + and – on the batteries to the marks inside the battery compartment.

2 Close the cover.

Operating range

Remote sensor

Within about 7 m

Notes

Do not drop or give the remote control a shock.

Do not leave the remote control near an extremely hot or humid place.

Do not spill water or put anything wet on the remote control.

Do not disassemble the remote control.

Dispose of batteries in a designated disposal area.

Batteries should always be disposed of with the environment in mind.

Always dispose of batteries in accordance with applicable laws and regulations.

If the remote control does not operate correctly, or if the operating range becomes reduced, replace all batteries with new ones.

When necessary to replace batteries in the remote control, always replace all batteries with new ones. Never mix battery types or use new and used batteries in combination.

Always remove batteries from remote control if they are dead or if the remote control is not be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment.

Caution

Never throw batteries into a fire.

12

HD-EP35KE_Eng.indd 12

07.8.30 7:34:39 PM

Image 12
Contents HD-EP35KB HD-EP35KE This HD DVD player employs a Laser System Result in hazardous radiation exposureLocation of the required label Following information is only for EU-member statesImportant Safety Instructions Precautions Do not use the unit when moisture condensation may occur Moisture condensation occurs during the following casesTable of contents Features Disc compatibilityDisc Specification Important notes about HD DVD HD output jacksCertain system requirements Customer supportIndex to parts and controls Front panelRear panel Remote control DisplayAccessories Remote controlSupplied accessories Loading batteriesTo program the remote control to operate your TV TV controlRelease TV CODE. The brand code is memorized While holding down, enter a codeResolution and connections Why Hdmi connection is most recommended?Preparation Proceed the following steps to set the player readyConnecting to a TV Via Hdmi inputVia component video input Via Video yellow inputConnecting to audio system Via Hdmi outputVia optical digital audio output Via 5.1ch analog audio outputLAN connection Via analog audio outputPower connection Powering onInput which the player is connected to Press ON/STANDBYSetting up the player LanguagePress / to select Language, then press OK Press / to select On Screen Language, then press OKTime Resolution Press To select Resolution Setting, then press OKPress To select Picture, then press OK Table below, then press OKAudio output Press / to select Audio, then press OKWhen a 2ch stereo system is connected to this player Crossover SettingFront Left / Front Right Center / L Surround / R SurroundTo adjust the player’s clock via the network time protocol Enter the proxy server address when your providerRequires proxy setting EthernetCookie Setting Network SpeedPlaying Playing a discPlayback starts If playback does not start, press Play To pause playback To stop playbackTo resume playback from the location last stopped To change playback speedTo select subtitles To select the soundTo select the camera angle During playback, press SubtitleTo locate a position To check the current statusTo play repeatedly Requirements for HD DVD discs/Web-enabled network content HD DVD playing options in the futureC/D buttons Cursor controlsOutput sound conversion table ADVCustomizing the function settings During stop, press SetupGroup Setting Disc Details To return to the previous menuSettings PictureAudio Language Language code list How to select a languageEthernet GeneralRemote Controller Sound Enable HdmiMaintenance Initialize Update FirmwareBefore calling service personnel Symptom RemedySpecification