Toshiba HD-EP35KB manual Speciﬁcation

Page 40

Speciﬁcation

Power requirement 36.0W

Power supply

220 - 240V AC 50/60Hz

Mass

3.3kg

External dimension

Width 430 x Height 59.5 x Depth 327mm

Signal system

Standard PAL/NTSC colour system

Laser Semiconductor laser

Wavelength: 405nm/650nm/780nm

VIDEO output

1.0Vp-p (75Ω), Sync signal negative, Pin jack x 1 system

Component output (Y, PB, PR) Y output (green), 1.0Vp-p (75Ω), Pin jack x 1 system

PB, PR output (blue, red), 0.7Vp-p (75Ω), Pin jack x 1 system each

Analog audio output

2.0V (rms), 2.2kΩ or below, pin jack (L, R) x 1 system

2.0V (rms), 2.2kΩ or below, pin jack x 6

Digital audio output (BITSTREAM/PCM jack) Optical connector x 1 system

LAN port 100BASE-TX/10BASE-T x 1

Extension port

1 system

HDMI output

19 pin, Type A connector

Remote control

Wireless remote control (SE-R0252-WEEE)

Operating conditions

Temperature: 41°F ~ 95°F (5°C ~ 35°C)

Position: Horizontal

Clock accuracy

Quartz (monthly deviation: approximately ±30 seconds)

•Designs and speciﬁcations are subject to change without notice.

•This model may not be compatible with features and/or speciﬁcations that may be added in the future.

•The illustrations and screens described in this manual may be exaggerated or simpliﬁed for easy recognition and may be slightly different from the actual unit.

INFORMATION ON CUSTOMER SUPPORT

HD DVD is a new and evolving format, so changes and improvements are possible. To obtain updated information about HD DVD and this product, as well as customer support information about this product, please contact Toshiba customer service for your country or http://www.highdeﬁnitiondvd.eu/.

©2007 TOSHIBA CORPORATION

Printed in China

Printed on 70% Recycled Paper

. GX1D00001780

HD-EP35KE_Eng.indd 40

07.8.30 7:34:52 PM

Image 40

Contents HD-EP35KB HD-EP35KE This HD DVD player employs a Laser System Result in hazardous radiation exposureLocation of the required label Following information is only for EU-member statesImportant Safety Instructions Precautions Do not use the unit when moisture condensation may occur Moisture condensation occurs during the following casesTable of contents Disc compatibility FeaturesDisc Speciﬁcation Important notes about HD DVD HD output jacksCertain system requirements Customer supportFront panel Index to parts and controlsRear panel Remote control DisplayAccessories Remote controlSupplied accessories Loading batteriesTo program the remote control to operate your TV TV controlRelease TV CODE. The brand code is memorized While holding down, enter a codeResolution and connections Why Hdmi connection is most recommended?Preparation Proceed the following steps to set the player readyConnecting to a TV Via Hdmi inputVia component video input Via Video yellow inputConnecting to audio system Via Hdmi outputVia optical digital audio output Via 5.1ch analog audio outputLAN connection Via analog audio outputPower connection Powering onInput which the player is connected to Press ON/STANDBYSetting up the player LanguagePress / to select Language, then press OK Press / to select On Screen Language, then press OKTime Resolution Press To select Resolution Setting, then press OKPress To select Picture, then press OK Table below, then press OKAudio output Press / to select Audio, then press OKWhen a 2ch stereo system is connected to this player Crossover SettingFront Left / Front Right Center / L Surround / R SurroundTo adjust the player’s clock via the network time protocol Enter the proxy server address when your providerRequires proxy setting EthernetCookie Setting Network SpeedPlaying a disc PlayingPlayback starts If playback does not start, press Play To pause playback To stop playbackTo resume playback from the location last stopped To change playback speedTo select subtitles To select the soundTo select the camera angle During playback, press SubtitleTo check the current status To locate a positionTo play repeatedly Requirements for HD DVD discs/Web-enabled network content HD DVD playing options in the futureC/D buttons Cursor controlsOutput sound conversion table ADVCustomizing the function settings During stop, press SetupGroup Setting Disc Details To return to the previous menuSettings PictureAudio Language Language code list How to select a languageEthernet GeneralRemote Controller Sound Enable HdmiMaintenance Initialize Update FirmwareBefore calling service personnel Symptom RemedySpeciﬁcation