Universal Remote Control URC-300 owner manual Basic Setup, Pre-Programmed Method

U R C - 3 0 0

Basic Setup

You can start setting up your Customizer using either the Pre-Programmed Method or the Learning Method. However, all the buttons of the Customizer are setup at once with the Pre-Programmed Method, so it is usually faster than the one-button-at-a-time Learning Method.

Pre-Programmed Method

1Power on the A/V component you wish to setup, so that you can test codes by sending power off commands.

Refer to the pre-programmed code tables on pages

233 - 47 and write down the code numbers listed for your A/V component. The code numbers are listed by categories of devices, then by brand. See page 33 for a category list.

3Press and hold the MAIN and ENT (Enter) buttons at the same time for approximately three seconds.

The top of the display will show “SETUP”. You are in SETUP mode now.

Note: You have 30 seconds to perform a step while you are in SETUP mode. If you don’t press a button within that time, the Customizer will time out and return to normal operation.

MAIN

ButtonENT

Button

5