Universal Remote Control URC-100 owner manual Advanced Setup, Own Two VCR’s? Set Aux to be VCR2

Page 15

U R C - 1 0 0

Advanced Setup

After you’ve finished all your basic setup, you can choose to make operation easier by customizing the Unifier just the way you want, using the Advanced Setup features described in this section.

Own Two VCR’s?

Set Aux to be VCR2

Any device button can be setup for ANY type of component (for example, you can make the AUX device button operate a second VCR). To setup a device button for a different type of component, use these steps:

1	Power on the A/V component you wish to setup, so that
	you can test codes by sending power off commands.

Refer to the pre-programmed code tables on pages

2 25 - 46 and write down the code numbers listed for your A/V component.

Press and hold both the SHIFT and ENT (Enter)

3 buttons for approximately three seconds. The top of the display will blink “SET” for a moment.

SHIFT	ENT
Button	Button

Note: You have 30 seconds for each step, otherwise the Unifier will time out automatically.

13

Image 15

Contents Page Thank You Table of Contents Congratulations Battery InstallationGetting Started E U n i f i e rC 1 0 Button LayoutLight Button Shift ButtonPre-Programmed Method Basic SetupLeft Right Channel Up Down Scan code Numbers E U n i f i e r Learning Method Ready Press and hold the same button on your old remote C 1 0 Volume Control Punch Through SET Own Two VCR’s? Set Aux to be VCR2 Advanced SetupThis step you choose the name of the device C 1 0 Editing Device Names AudioOnce the character you want appears, move to M1 ## C 1 0 Macro Button SetupPause C 1 0 Overview of Erasing Erasing One Learned CommandE U n i f i e r Erasing All Learned Commands in One Device Erasing a Macro C 1 0 Erasing All Learned Commands in ALL DevicesRecalling Pre-Programmed Settings E U n i f i e r Erasing All SettingsOptional Expander E U n i f i e r Pre-Programmed Code Tables Audio Amps, Preamps and Receivers Brand Three Digit Setup NumbersKoss Command Button Location Audio Command LocationsSurr CD CD Players and ChangersLotte CD Command Locations DVD Laser Disc Players DVD DVD Players and ChangersDVD Command Locations Angle AUX Tape DecksAUX Lighting & Custom Products AUX Command LocationsDeck B SAT Satellite ReceiversSAT PVR TiVo, Replay etc TV Televisions, Projectors, Monitors SAT Command LocationsAmpro Matsui TV Command Locations Auto CH VCR Video Cassette RecordersMEI Input VCR Command LocationsCBL Cable TV and Web TV Cable Command Locations Right REW Stop Can I program the Unifier on a computer? Frequently Asked QuestionsWhy does the display flash at me sometimes? What is a Macro?Who can I call for more answers? If the batteries run out, will I lose my settings?Specifications WarrantyM O M O M O OCE-0023A Rev