IMPVE4P manual 1.0 4/11/03 4:34 PM Page 11
4. | Aim the remote control at the TV and |
| slowly alternate between pressing POWER |
| and TV. Stop when the TV turns off (after |
| pressing POWER). |
| NOTE: In the search mode, the remote control |
| will send IR codes from its library to the selected |
| device, starting with the most popular code first. |
5. | To lock in the code, press and release SET. |
| The LED will blink twice. |
6.To search for the codes of your other devices, repeat steps 1 through 5, but substitute the appropriate device key for the device you are searching for.
CHECKING THE CODES
If you have set up the remote control using the Searching For Your Code procedure (on the previous page), you may need to find out which
For example,to find out which code is operating your TV:
1. 
On the remote control, press TV once.
2. 
Press and hold SET until the LED (red light)
blinks twice, then release SET.
3. 
Enter 9 - 9 - 0. The LED will blink twice.
4. 
To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (e.g., three blinks = 3) and write down the number in the leftmost box in the TV code boxes on page 10.
NOTE: If a code digit is “0”, the LED will not blink.
5. 
Repeat step 4 three more times for 
remaining digits. Use 2 for the second digit, 3 for the third digit, and 4 for the fourth digit. Write down the code digits in the remaining TV code boxes on page 10.
6.To check for codes of other devices, repeat steps 1 through 5, but substitute the appropriate device key for each device you are checking. Write down the device’s code digits in the appropriate code boxes on page 10.
11