IMPVE4P manual 1.0 4/11/03 4:34 PM Page 12
PROGRAMMING A MASTER POWER MACRO
In its default state, the POWER key on the One For All DVD Expert Universal Remote Control will individually power your home entertainment devices on or off. However, you can also program a Master Power Macro onto the POWER key that will sequentially turn on or off all the devices with a single key press.
Programming The Power Key For The Master Power Macro
1. 
Press and hold SET until the LED (red light)
blinks twice, then release SET.
2. 
Enter 9 - 9 - 5. The LED will blink twice. Then press POWER once.
3.For the first device you want in the power-
on sequence, press its device key (e.g., CBL/SAT) once.
4.Repeat step 3 up to three more times to add desired devices to the
5. 
To save the settings and exit the program, press and hold SET until the LED blinks twice, then release SET.
Operating The Master Power Macro
1. 
After programming, point the remote control at the devices and press POWER for at least 2 seconds to sequentially turn on or off your devices.
NOTE: When POWER is pressed for less than
2 seconds, a power command will only be sent to the
2.You will see the devices turn on or off according to your programmed sequence.
NOTE: The
NOTE: If one or more devices does not have a POWER key, the power off/on sequence may be slightly delayed when the remote control signals the device(s). This action is normal.
12