Universal Remote Control URC-4041 manual Using Channel Scan, Press FAV once

IMPVE4P manual 1.0 4/11/03 4:34 PM Page 15

3.Press DVD/VCR once, then press AUX once.

The LED will blink twice.

4.The AUX key is now ready to be set up to

control your second DVD player. See Programming Device Control on page 9.

To re-assign other device keys to the AUX key, repeat steps 1 through 4 with a sequence from the below chart:

NOTE: Only one device can be assigned to an unused device key at a time.

To Re-Assign Device	Perform Sequence
AUX as 2nd TV key:	SET - 9	- 9 - 2	- TV - AUX
AUX as 2nd CBL/SAT key: SET - 9		- 9 - 2	- CBL/SAT - AUX

When a re-assignment is done, the LED will blink twice to confirm your choice. At that time, you will need to program the remote control for the new device (see Programming Device Control on page 9).

USING CHANNEL SCAN

In the DVD/VCR, CBL/SAT, or TV mode, use the FAV key to start a 3-second scan of all channels. If programmed, use the FAV key to scan only your favorite channels to view a desired channel (see Programming Favorite Channel Scan on next page. )

1. If Favorite Channel Scan has been set up, skip to step 2. Otherwise, press DVD/VCR,

CBL/SAT, or TV once.

2. Press FAV once.

•If Favorite Channel Scan has been set up, scanning of favorite channels will start and cycle through stored channels for

3 minutes or until stopped by pressing any key.

•If Favorite Channel Scan has not been set up, scanning will start with the current channel, then proceed to the next channel up and cycle through all channels for 3 minutes or until stopped by pressing any key.

3.To stop scanning channels at any time, press any key once.

15