Operating Non-Preset
Components
— Learning Function (continued)
3Press and hold the input select button (e.g. VIDEO or CD etc.) on your amplifier’s remote control, until “OK” appears in the display.
During data transfer, “LEARN” stops flashing.
After data transfer is complete, “OK” appears in the display. Then, the Commander returns to its state in Step 2.
| remote control |
VIDEO | of amplifier |
4Select “EXIT,” then press the Jog dial to finish Learning.
To cancel Learning
Press SET.
AMP AMP
VIDEO1 OK
LEARN LEARN
during data transfer
AMP
VIDEO1
LEARN
data transfer complete
If “NG” flashes twice, and the component name flashes again
Learning was unsuccessful. Try again from this Step.