Toshiba 22CV100U Viewing the digital signal meter, Setting the Time Zone, Reset Factory Defaults

Chapter 5: Setting up your TV

Viewing the digital signal meter

You can view the digital signal meter in the ANT/ CABLE digital TV input source only.

To view the digital signal meter:

1From the Setup menu, press or to select Installation and then press .

2Press or to highlight Terrestrial, and press or to select Signal Meter and then press .

3Press to select the antenna input and digital channel whose signal you want to check.

Note:

•The physical digital channel number listed in the Signal Meter screen may not correspond to a virtual TV channel number. Contact your local broadcasters to obtain the RF channel numbers for your local digital stations.

•The signal strength does not change between virtual channels on the same physical channel.

Setting the Time Zone

The Time Zone setup will allow you to specify the correct time zone for your region. This feature will allow the TV status information to show the correct time zone information for your viewing area.

To set the time zone:

1From the Setup menu, press or to select Installation and then press .

2Press or to highlight Terrestrial, and press or to select Time Zone and then press .

3Press and then or to select the region.

4Highlight Done, and then press .

After the time zone has been set, you will be asked to set the current Daylight Saving Time status.

To set the Daylight Saving Time Status:

1Press or to select Yes or No, highlight Done, and then press .

Viewing the system status

1From the Setup menu, press or to select Installation and then press .

2Press or to highlight System Status, and press or to select System Information and then press .

3Press or to scroll through the menu bar to select Support Information and view the related information.

Reset Factory Defaults

1From the Setup menu, press or to select Installation and then press .

2Press or to highlight System Status, and press or to select System Information and then press .

3Press or to scroll through the menu bar to select Factory Defaults.

4Enter your PIN code (or 0000 if no PIN code has been set).

5 Highlight Yes and then press . The TV will turn off automatically after a few seconds. After the TV turns off, unplug the TV power cord and then plug it in again to complete the reset process.

To cancel the reset:

Highlight No and then press .

32